- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If any of your electronics system not using for long period, remember this things( detach the battery or power source , take out cassette or memory card, if the unit use in built chargeable battery, charge it occasionally.
just connect to the power, you don"t power on your camera, the charging light will flicker then push the eject button, remember do not on the power of your cam, hop that this will solve your problem.
Follow this procedure to troubleshoot if the cassette compartment will not open or the tape is stuck and will not eject. IMPORTANT: If your camcorder model has a RESET button, first try pressing this button. If there is no RESET button, or pressing the button does not resolve the issue, continue with the troubleshooting steps below.
Turn off the camcorder.
Remove the battery from the camera.
Remove the AC power supply from the camera.
Slide the power switch on the camera to the VTR , VCR or CAMERA mode for 15 seconds.
there is a fuse blown it happens alot just make sure when you send it in that the shop is a certified jvc or a jvc only repair shop some places fix alot of different brands of cameras and sometimes you might not get it fixed right away because of the workload or not at all
Take the battery out and turn selection switch to camera and then turn it off. Put the battery back in and its working again.
if that doesn't work try
Try smacking the side of the camera relatively hard with the palm of your hand. Eject the tape and reinsert. You may need to do this a couple of times. good luck
please mark the post with a fixya
The most frequent cause of this type situation is not having a power source attached, or a depleted battery pack.
Once the power source is available, some models require manually unlatching and opening the cassette compartment cover. When the cover is fully open, the videocassette will eject automatically.
Please try the following procedures.
1. Attach the power source to the camcorder correctly or use a fully-charged battery pack.
2. Fully-open the cassette compartment cover until it stops while sliding and holding the OPEN/EJECT switch.
The videocassette will eject automatically after a few seconds.
If the videocassette still will not eject, seek assistance from a Canon Service Facility.