Question about RCA P61960 61" Rear Projection Television

1 Answer

I have a broken outer screen.

The outer grey grooved screen on my PS80690 broke while transporting it. Does any one know where I could find one or if I can use a different material to replace it with? The manufacturer does not have the part anymore so they can't help out.

Posted by on

  • maxxon262 Feb 13, 2009

    The protective outer screen and the dark glare screen of my P61960 are broken and I would like to know where I can find these replacement parts.

    Also, while trying to move the TV, I forgot to disconnect the Cable wire, now the connector on the back is slightly damaged. Everything else onthe TV works perfectly.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • RCA Master
  • 5,138 Answers

Check out all TV Shops ask them if they might have one.

Posted on Feb 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Broken outer screen on my toshiba progection


Manufacturer Toshiba Part Number 23311898 Description SCREEN FRESNEL 42H Manufacturer Toshiba Part Number 23311897 Description SCREEN LENT 42H81 Manufacturer Toshiba Part Number 23311863 Description SCREEN PROTECTOR

Nov 13, 2009 | Toshiba 42H81 42" Rear Projection...

1 Answer

Broken plastic screen


After doing some searching what I have come up with is that your options are limited to contacting the manufacturer for a replacement screen or going the ebay route which looking there does not seem to have any possibility at the moment. You can also check with a tv repair shop preferably a mom and pop type joint, many of these places will have spare parts laying around.

Aug 21, 2009 | Toshiba Projection Televisions

1 Answer

I have a JVC 56" TV,and I want to clean the inside screens and lamps,when the teck guy did it he unscrewed a few screws and wiped the inside out and was done. Does anyone know how to do this ????


You need to unscrew the base first. There's three screws on the back edge on either side that need to be removed (standard Phillips screwdriver will do). Then gently pull the front cover off. It's clipped in place along the top edge (just below the screen) in two places on either side of the power button; gently pulling the side back will release it.

When that's off there's several screws along the sides & top of the upper front bezel that need to be removed as well, just like with the lower section. The difference is that there's also some screws around the power button panel that need to be removed as well. These are smaller, and if I remember correctly, there's either five or six of them. Removing these also means the that power button panel will be loose. The screen will come off in one piece, but be careful... The two bottom corners fit over some support rods, so you'll need to pull it further out before you try to lift it up or sideways.

And be doubly careful about that screen. There's three sheets that make it up; the outer, glossy protective screen, the middle, grey lenticular screen and the inner screen. The inner screen is the most easily damaged. I know - I damaged mine and now need a replacement. This inner screen has extremely small circular groves on the front-facing side and horizontal grooves on the rear-facing, or now-exposed, side. Use a very soft cloth - microfiber preferably - and wipe from side to side to avoid damaging the fine grooves. You'll probably want to do this with the screen vertical so no new fresh dust falls on it before you put it back on. I'd also recommend removing any jewelry or wrist watches, or anything else that could pose even a remote scratch hazard; the grooves on this screen are extremely delicate.

Replacing the screen is just a simple matter of reversing the steps above.

He Who Really Likes This Model, But Wants To Go Bigger Now.

May 05, 2009 | JVC AV-56WP30 56" Rear Projection...

1 Answer

Outer screen broke while transporting


andrews electronics.
you need an open acount with them if you dont have one
i can order for you.
see my web site www.allrepair.us

Jan 04, 2009 | Panasonic PT-53WX42 53" Rear Projection...

2 Answers

Rca p52937 52in


Have model number and call either mcm 18005434330 or tritronics 18006383328

Jun 06, 2008 | RCA P52937 52" Rear Projection Television

1 Answer

Mitsubishi Model VS60607 Big Screen TV


There is a store called Big Screen TV Replacement Parts on EBAY that sells screens.

May 27, 2008 | Mitsubishi WS-65807 65" Rear Projection...

1 Answer

Pioneer SD-T5022 Broke Screen


Call your local TV repair shops ask if they have any used screens ,From sets junked out. most shops sell them 100.00 or little more.order new from factory 500.00 Good Luck with your hunt .ThankYou for using FixYa. Have a Nice Day.

Feb 08, 2008 | Pioneer SD-P50A5-K 50" Rear Projection...

1 Answer

Ripped outer screen


Trew Did you ever find a solution to your problem? I also need a TV screen. I lost mine the same way.

May 13, 2007 | Mitsubishi VS-50605 50" Rear Projection...

Not finding what you are looking for?
RCA P61960 61" Rear Projection Television Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Projection Televisions Experts

The Wyzzyrd

Level 2 Expert

83 Answers

D. E. Hev

Level 3 Expert

1059 Answers

Ron Dufek
Ron Dufek

Level 3 Expert

398 Answers

Are you a RCA Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...