Question about Hoover Nextra 160 HNWF 3137 Front Load Washer / Dryer

1 Answer

Water will not drain

The machine was working fine and then it just stopped and when i turned it off and opened the door, there was water at the bottome of the machine.

Posted by on

  • Anonymous Feb 28, 2009

    Water will not drain, do not know how to open filter?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 135 Answers

Check the filter located behind the kick plate at bottom front of machine.
Thanks for using Fixya.

Posted on Feb 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

ASKO W620 QUATTRO 1200 RPM front load washing machine. This morning clothes were still very wet, I turned on spin cycle & some water came into machine?? Turned off water at tap - now can't open door to...


Probably a blockage in the drain hose at the back of the machine. Easy to fix. Turn machine off then pull machine out so you can easily access behind. Have bowls and cloths/rags at hand for water spillage. The drain hose is located low down and links into your sink drain, it is held in place by a clip. Remove the clip and hose. This will start to drain the machine so make sure you have enough vessels to catch the water. When the water has stopped draining, check the hose for blockages : buttons / coins / hair grips / paper etc. Also check the hole where the hose attaches to the machine. Remove items then blow through the hose to see if there are any other restrictions. If all clear then replace hose on back of machine. Clear up. Move machine back to normal position. Switch on and set to spin. When complete, the machine should shut off cycle and unlock door. This will save you at least 100 pounds on a call-out. Good luck.

Jun 18, 2014 | Washing Machines

Tip

Door not opening in Equator / Hirundo (EZ3612CEE/EZ2512CEE/EZ1612V)


Door not opening in Equator / Hirundo ( EZ3612CEE / EZ2512CEE / EZ1612V )
If the door in the unit is not opening it means that the unit has not completed the cycle selected or else there is something in the unit that has malfunctioned. In such cases if there are clothes in the unit, one tries to open the door by pulling the door handle which mostly results in breaking of the door handle and also the clothes in the unit cannot be removed
To avoid the breakage of the door handle and also the damage to the clothes you can follow the following procedure to open the door.
  1. Make sure that the machined is turned OFF.
  2. Set the dryer & wash temperature knobs to the off position (12 o'clock / pointing vertically upwards)
  3. Turn the wash program knob to cycle no. 4 & advance the knob by 6 clicks in the clockwise direction.
  4. Turn the machine ON by pressing the ON/OFF Switch.
  5. You will observe that the machine starts draining out the water and also the drum starts moving ( goes into the spin cycle)
  6. Wait until the water is drained out of the machine, this can be understood by paying attention to the sound made by the drain pump when it initially starts draining out the water and once the water has been drained out.
  7. Once you are sure that all the water in the unit has drained out switch OFF the power.
  8. Try opening the door now, the door should open.
Once you have managed to open the door, it is advisable to reset the unit first before further using the machine. For the Reset Procedure Click Here

on Mar 01, 2010 | Washing Machines

1 Answer

Machine stops during wash cycle full of water


object stuck in pump, drain water remove and clean pump re start

Dec 09, 2013 | Washing Machines

1 Answer

How make the door open automatically when finish the laundry


Hello,

Welcome to FixYa,

These model of Asko ( based on the number listed ) do not have such an option. On these models the Program Control knob must be at the end of a program (at the 12:00 or zero position) to open the glass door.

If you need to stop or interrupt a program after you start the machine, turn the Program Control knob

to 10 (Drain). Any water in the machine will be pumped out and you can then press the Door Open

button ( ) to open the door. To restart the washer, close the door and turn the controls to the desired
settings.

On the electronic control models, if you need to open the glass door during a wash or rinse cycle, press and hold the Door Open button for three seconds. The machine will stop and automatically drain enough water so the door can be opened safely. The program will resume when you close the door. The inlet valve will come on to

ensure the proper water level.


In case of mechanical failure, you can use the Emergency Door Opener located by the drain pump. To use the Emergency Door Opener, remove the screw holding the cord handle (loop) and pull the cord down.


Hope this answers your question even if it isn't necessarily the answer you wanted. Thank you for choosing FixYa and good luck.


Regards,


Macmarkus :)

Jan 10, 2011 | Asko W6021 Front Load Washer

1 Answer

Stopped mid cycle still has water in it cant drain water or get door open or get it to start again ?


you can use a wet dry shop vac and attach it to the end of the drain hose to remove the water.once the water is gone then you should be able to open the door.then you need to check the drain hose and the drain pump for any obstructions or some thing stopping the drain pump

Jun 19, 2010 | Washing Machines

1 Answer

Maytag washer MAH2400AWW problem. It stopped in the middle of washing and/or rinse cycle without finishing the work. It won't spin and the water is not draining. It only makes buzz sound and can't start...


Hi and welcome to Fixya. Usually when a unit stops in mud-cycle and the motor buzzes there is something lodged between the wash tub and the outer tub.

Draining must be done manually before you can open the door. You can try dropping the drain hose down and gravity drain the washer. If that does not work then the only other option is to unplug the unit and disconnect the tub to pump hose. Be prepaired for an immediate water mess if you manage to get the hose completely free of the fitting all at once. You only need to drain it until the water level is below the door seal.

Once you get the water out open the door then sue a flashlight to search for what it is that is preventing the tub from turning.

Don't forget to reconnect and clamp the drain hose if you disconnected it and plug the washer back in.

Thanks for using Fixya. Kelly

Feb 08, 2010 | Washing Machines

1 Answer

LG TROMM washing machine can't open door


You need to unplug the machine, and drain the water from the drain hose, accessing the drain pump.

Once you access the drain pump also remove all obstructions in drain lines, this often fix teh problem.

If you do not have done anything similar before, then it is better to call the technician.

Jan 08, 2009 | LG TROMM WM2688H 4.0 cu.ft. Front Loading...

3 Answers

Washer Dryer - drum is filled with water even when switched off and door can still open!


Try the valves inside the back where the water hoses connect to the machine they should default to the closed position when water is not required

Oct 31, 2008 | De Dietrich LZ9619 Front Load Washer /...

1 Answer

Washing machine fills with water when not in use.


You have an open solenoid on your water valve where the fill hoses connect. Change the water valve and you should be good.

Jul 25, 2008 | Washing Machines

Not finding what you are looking for?
Hoover Nextra 160 HNWF 3137 Front Load Washer / Dryer Logo

168 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hoover Washing Machines Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

Chris Hall
Chris Hall

Level 3 Expert

842 Answers

Are you a Hoover Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...