Question about Sony KP-53XBR45 53" Rear Projection Television

1 Answer

TV has sound no picture, Sony Videoscope xbr

I just bought this tv used, sony videoscope xbr 53", and when I got it home, the sound worked fine, but there was absolutely no picture. Also the timer/standby light flashes and does not stay constant. It was sprinkling out and I covered it up with plastic, but the back got a little moisture in it. What's up?

Posted by on

  • ra_17 Feb 22, 2009

    I have a Sony Videoscope XBR, model number KP-53KB R45. No Sound, No Picture. When powered on it turns on, blinks twice and immediately turns off.



    Can you help? Thank you.

  • gbrodt62 May 11, 2010

    KP53XBR45 6 short 1 longer flash

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,234 Answers

Please post both the exact model number (on the back) and the blink count. The standby light should be blinking a repeated pattern. That info will indicate the problem circuit and allow us to provide you with the proper parts/steps to resolve this.

Thanks,
Dan

Posted on Feb 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sony videoscope xbr


would think you need to replace the cable board etc. the signal is not getting in and out right. can also be a fault on the power board giving the wrong volts so would check this to. it will tell you on the board what volts is supposed to be. the 5v and 12v should be spot on other volts will vary a little. also check the capacitors for the caps to be bowed up and a brown/ yellow gunk around them and under the board this can be a sign they are failing.

Feb 25, 2014 | Projection Televisions

1 Answer

My sony videoscope XBR tv has a pink picture and no control. Also nothing is in enlish.


the model listed is a very old set---parts may not be available----language can be selected in the menu but the pink may be a adjustment of the screens (controls) or a circuit problem.

Aug 26, 2012 | Sony KP-53XBR45 53" Rear Projection...

1 Answer

Sony videoscope xbr TV screen keeps blinking in and out...sound is fine. Blinking 5 times then cut off ...any solutions ...it is really annoying! !!


Hello,

Your power supply board is dead, u know basic electronics' and soldering? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up on it top.Replaced these gases leakages capacitors will get your TV power stable,and work again.Or tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.
Take care in solving the problem

Aug 06, 2011 | Sony Projection Televisions

1 Answer

Can't turn off pip on sony XBR videoscope TV


Look on your TV remote and press the button clearly labled PIP or Picture-In-Picture and press that button over and over. It will cycle through all the PIP modes until it turns it off!

May 02, 2011 | Projection Televisions

1 Answer

HI I have a 1998 Sony Videoscope XBR 53 in. Projection TV. When you turn it on the sound is fine but sometimes the picture comes right on and sometimes it can take hours. Can anyone give me some advice....


hello well it's and old tv, my guess it could be capacitors in the power supply or even dry joints on the power supply board, it would be best to have someone with electronic experience to have a look at it

regards
shaun

Oct 06, 2010 | Sony KP-53S65 53" Rear Projection...

1 Answer

Hi. My Sony Videoscope XBR's Convergence Allignment


I happen to share this same problem. The alignment of the gridlines on the standard convergence panel are completely abnormal, and if I attempt to auto-adjust the TV, it flashes different colors on the sides of the screen , and then turns off the convergence settings.

Feb 01, 2010 | Sony Projection Televisions

1 Answer

Sony Videoscope XBR 53


This is a convergence problem. Look in the back for a couple of large black ICs attached to a heatsnik. These should be marked STKxxx. These are the convergence ICs and either have bad connections or are defective. If you can solder, try resoldering the pins on these ICs. If that fails to resolve the problem, replace the ICs. There may be other parts that need to be replaced as well. I'll look up your model to find the other parts to check. The convergence board as an assembly, I believe, is no longer available. The parts that you require are available.

Dan

Sep 18, 2008 | Projection Televisions

1 Answer

Sony Videoscope XBR TV


just need to balance the three colors red,green and blue that may help remove the front covers and look for black module that have sccree and focus controls just move a little bet left or right be carefull because you can loos the picture e-mail me for more info

Apr 07, 2008 | Sony KP-53XBR45 53" Rear Projection...

1 Answer

Home theater reception


you need to unlpug your set and reconnect everything over and see what it does.if that does not work have a tech check your system.your sony recviever is the culprit let that be checked.good luck

Apr 05, 2007 | Sony KP-53XBR45 53" Rear Projection...

Not finding what you are looking for?
Projection Televisions Logo

1,142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Projection Televisions Experts

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1128 Answers

Ap12
Ap12

Level 2 Expert

103 Answers

Jason Harris
Jason Harris

Level 2 Expert

256 Answers

Are you a Sony Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...