Question about Ford Code-Alarm Code Alarm Transponder

2 Answers

Ford transit lock problem

Ford 1998 transit unable to open locks with keys or remote

Posted by on

  • Anonymous Mar 07, 2009

    loc but wont unloc

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 249 Answers

I, i get this all the time, had lots of old transits. get as many ford keys as you can borrow friends from escort mondeo transit, these locks are **** some 1s key will open it, when doors are open u have to remove locks and soak them in oil leave under engine oil all night, fixes ur prob.

Posted on Aug 19, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Where is the sender on a 1999 Ford Transit Diesel

Posted on Feb 03, 2013

3 Suggested Answers

  • 18 Answers

SOURCE: transit doors not locking

james i have had the same problem on a transit an trace the problem in the wiring to the rear right door where the wirin goes through the plastic slider between the door and the vehcle i had to cut out the damaged wiring and run new and solder up make sure the wires you put in are long enough too so you can open the door all the way , failing this think logically which is the door opened and closed the most ,ther might be your prob in the wiring between the door and vehcle

Posted on May 16, 2009

  • 4706 Answers

SOURCE: ford fiesta ghia 1998 model central locking key

This is a common problem after changing the Key Fob battery.

The solution is to remove the fuse feeding the Cental Locking for 10 minute...Replace then all should work fine

Posted on Sep 12, 2009

  • 20 Answers

SOURCE: Ford Transit 100 T280 2002 immobiliser fault,

if its a immobiliser fault you may need to get the pump reprogrammed

Posted on Jun 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rover 25 keeps locking itself,battery key wont work neither will manual key open it, has been locked for 6 weeks now unable to get in, any answers?


Sometimes electronics get stupid and this is a shot in the dark, but I would disconnect the battery and leave it set for 24 hours hook it back up and see if it starts working. Hope it helps good luck!

Aug 28, 2013 | Ford Code-Alarm Code Alarm Transponder

1 Answer

My van unlocks itself after i lock it either with the key or remote


is the dome light always on, if it is then your van thinks your door is open and it won't let you lock the doors

Mar 17, 2010 | Ford Code-Alarm Code Alarm Transponder

1 Answer

Central locking on ford transit wont work


hi my central locking on my 04 transit connect is not working can anyone help

Jan 08, 2010 | Vehicle Security Systems

1 Answer

How to program remote key of mercury mystique 2000


I am assuming this is the factory key fob.
Read all instructions before attempting.

FORD KEY PADS/REMOTES
  • Insert key, turn ignition off-to- on eight times in succession, ending with key in on position doors will lock, unlock to verify in programming mode
  • Press any button on new remote, doors will lock, unlock to verify
  • Do the previous step with the second remote, doors will lock unlock to verify.
  • Turn ignition off. Doors will again lock, unlock to verify.

Dec 23, 2009 | Mercury Vehicle Security Systems

1 Answer

Transit doors not locking


james i have had the same problem on a transit an trace the problem in the wiring to the rear right door where the wirin goes through the plastic slider between the door and the vehcle i had to cut out the damaged wiring and run new and solder up make sure the wires you put in are long enough too so you can open the door all the way , failing this think logically which is the door opened and closed the most ,ther might be your prob in the wiring between the door and vehcle

May 10, 2009 | Ford Code-Alarm Code Alarm Transponder

2 Answers

2006 Mazda 5 keyless remote fob


I am a technition for mazda, and if the lights are coming on to the keyfobs, the batteries are fine. What procedure did you follow?
1. Take key out of ignition
2. Shut all doors
3. Open drivers door
4. Insert key to ignition
5. Cycle between On & Lock 3 times, leaving key in Lock
6. Close and open the drivers door 3 times, leaving the door open
7. The Locks should cycle.
8. Press the Panic button on the remote twice.

Jan 31, 2009 | SMC Alarm & Keyless Entry System for Mazda...

1 Answer

Remote key will not open door


hi, gareth hear
i think this mite work 4 u

get in your car and put key in ignition turn 1 turn then wait approx 15 20 secs for light in clock to go red then take key out light should stay lit, next get out of your car close door then lock it and open it, when u open car light in clock should flash 3 times, next get out of car hold lock button on your remote down and push open button 3 times (keeping lock button down and remote pointed at reciver) next lose go of both buttons and red light on key should flash 3 times at the same time as clock inside the car.
next get in your car with key! then start her up and turn off get out of car close door and push button to lock (it should lock) if not get back in start her up again and turn off, then push the door locks inside the car then open get out and your car will lock this time!!!!!!!

this will work 4 u!!!

good luck

Dec 14, 2008 | Ford Code-Alarm Code Alarm Transponder

2 Answers

Ford fiesta ghia 1998 model central locking key


This is a common problem after changing the Key Fob battery.

The solution is to remove the fuse feeding the Cental Locking for 10 minute...Replace then all should work fine

Nov 30, 2008 | Ford Code-Alarm Code Alarm Transponder

3 Answers

Ford fiesta transponder problem


I have a 2002 fiesta and recently it has been stopping on eac failure and then the imobiliser light keeps flashing and the car wont start not even turn over ha any one got a solution for this?

Thanks llinos

Nov 01, 2008 | Ford Code-Alarm Code Alarm Transponder

Not finding what you are looking for?
Ford Code-Alarm Code Alarm  Transponder Logo

2,574 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Vehicle Security Systems Experts

xxxxxx xxx

Level 3 Expert

4706 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Larry Spears
Larry Spears

Level 3 Expert

625 Answers

Are you a Ford Vehicle Security System Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...