It says there is a paper jam and there's not!

Open the machine and remove the paper tray, the drum tray, the transfer belt and the fuser. Check all for a sheet or part sheet of paper. replace all and retry.If still register a paper jam have a look underneath to see if one of the paper pick up sensors is jammed open.

The error code 50 indicates a paper jam condition. Whether there's actually still paper jammed or not, it's sensors are still indicating a jam. Check again for a bit of paper, or there may be a faulty sensor.
Check out this link: Brother for further information.

you might try this:

The lights continually flashing indicate a paper jam or the printer being out of ink. Check/clear any paper jam and verify the ink cartidge is set correctly.

indicate paper jam light but not paper jam in it , some times it it works what shall i do

hi i hope i can help you? remove the cover from the machine and load paper as normal. and watch if the mechanics is sticking or anything that you can see give a clean with wd40clean all rollers check that you are puting in the correct amount off paper.check for loose connections.check for dirt on the switches.

Hi,



. Switch off the printer and disconnect the power supply. Allow any residual charge inside the all-in-one printer to dissipate before putting your hands or any metal tools inside the chassis.

2. Pin down the exact location of the jam. The 3 hot spots for a jam are before a sheet completely leaves the paper tray, anywhere between the feed tray and print carriage or between the print carriage and output tray.

3. Take off the front paper tray if the sheet jammed while still in the front area of the printer. If here, you should be able to see most of the paper.

4. Pull the sheet with both hands and steady pressure. Do not tug as you might rip the paper, leaving a piece deeper inside the machine.

5. Open the back panel to reach paper jammed between the feed-tray area and print carriage. Carefully remove the jammed paper.

6. Use the carriage access door to get at a jam further inside the printer. You may need to remove the print carriage to get to the jam.

7. Replace all parts and return any access panels to their closed and locked positions. Plug your printer back in and flip the power switch.

canon i960 -three flashing orange lights (paper jam error) but no paper is jammed. The print cartridge will not slide to center either-- I have tried to get the printer into service mode, but cannot get there because the orange lights never stop flashing.

Try to find thge combination of buttons that reset the printer. there are many possiblities due to the modles - but try pressing any 2 and whilst holding them down switch off and then on again. Also this utility could proce use full. When it is loaded -right click the task bar icon. www.ssclg.com

turn the printer off, count to ten, then note the light sequence ie: flashing organge solid orange, flashing green or solid green