Question about Psi Blue Max 2200 High Pressure Gas Power Washer

2 Answers

Broken plastic part that covers the pull rope assembly

2200 Blue Max gas powered pressure washer. Where do I get parts??

Posted by on

  • Anonymous May 17, 2009

    PLASTIC PART FOR PULL ROPE BROKE.

    MLW

  • Anonymous Mar 15, 2014

    When I pulled the coil to start pressure washer it locked up

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Psi Master
  • 1,423 Answers

May be here refer them to the right place but not for shure http://www.repairclinic.com/RepairHelp/Pressure-Washer-Repair-Help

Posted on May 12, 2016

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 239 Answers

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the wheel from my gas powered pressure washer?


usually its an end cap that has to be pried off some are covered by a plastic cap if so you will have to get another because these have permanent fasten and will have to be broken off

Aug 07, 2013 | Psi Blue Max 2200 High Pressure Gas Power...

1 Answer

Need a replacement hose for the Blue Max pw2200/03435 power washer (2200 psi)


Check jackssmallenginerepair.com or ereplacementparts.com they should have what you need.

Jul 25, 2011 | Psi Blue Max 2200 High Pressure Gas Power...

1 Answer

I have a husky 2200 pressure washer. What do I set gap on spark plug. (Lost insturctions)


20 thousands or about the width of two match book covers stacked.. there not that fussy, good to be close though

Jun 06, 2011 | Psi Blue Max 2200 High Pressure Gas Power...

1 Answer

Small plastic hose on pressure washer where does it go? My grandson got to this washer and pulled it off - where I don't know.


There is a plastic hose that is for detergent injector that goes on valve body just below your pressure washer hose

May 15, 2011 | Psi Blue Max 2200 High Pressure Gas Power...

1 Answer

What Spark Plug do I use for my Blue Max 2200 Power Washer.


Spark plugs: BPR6ES (NGK), W20EPR-U (DENSO). You cna cross ref any other equivalent with a spark plug cross ref book.

Thanks for choosing Fixya.

Kelly

Aug 12, 2010 | Psi Blue Max 2200 High Pressure Gas Power...

2 Answers

The pull cord on my pressurewasher just broke How do I fix it?


Usually you have to take the shroud that contains the recoil starter assembly off to get to it. You may have to take it apart to fix the rope. If it broke on the end nearest the starter, you probably have enough rope left to reuse it. Usually they break right at the starter, due the the constant bending and rubbing. Pay attention to how it comes apart, and make sure to rewind your spring before putting the rope back on the pulley, otherwise it will not wind back up.

Apr 24, 2010 | Psi Blue Max 2200 High Pressure Gas Power...

1 Answer

Can't find replacement recoil kit


What engine is on your presure washer? I really need a model number to give you the correct information.

If you have the engine model number you can look the engine up on the net at:
http://jackssmallengines.com/help.cfm
and find your recoil assy.

If it is just the rope that broke you can take the recoil to any lawn mower repair shop and they will repair your recoil by replacing the needed parts or replace the rope. You do not need to take the whole unit to the lawn mower repair shop. FYI a NEW honda recoil assy ranges from $32.00 - $68.00 depending on net source.

Thanks for using FixYa.

Kelly

Apr 16, 2010 | Psi Blue Max 2200 High Pressure Gas Power...

1 Answer

I have a Blue Max high presure washer, 2200 psi.


Hi Greg. Walk into your nearest Lawn Mower parts supply with your engine model number (usually on the recoil) and they will have the replacement part or repair your old one. It is less expesive to have the old one repaired unless the support struts have broken. 2200 PSI should have a Honda GX160.
engine:

Here is another source....
http://www.northerntool.com/shop/tools/product_200327175_200327175

They can range from $32.00 to $68.00 depending on source.

Honda PN is: 28400-ZH8-013ZA (do net search this number) Or call your local Lawn Mower repair Supply with the number.

If you have a Briggs & Stratton engine I will need the ENGINE model number off of the air shroud just above the spark plug.

Thanks for using FixYa.

Kelly

Apr 05, 2010 | Psi Blue Max 2200 High Pressure Gas Power...

1 Answer

Were can i fine parts for a blue max perrure washer .call me back at 229 759 6659. thanks


Homier makes the blue max pressure washer. The # for the warehouse is 260-356-9477.

Jul 21, 2009 | Psi Blue Max 2200 High Pressure Gas Power...

1 Answer

Need parts for Wand


yes go to Northern Tool supply Lowe's or HomeDepo any of these places should hace what you are looking for

Feb 02, 2009 | Psi Blue Max 2200 High Pressure Gas Power...

Not finding what you are looking for?
Psi Blue Max 2200 High Pressure Gas Power Washer Logo

Related Topics:

417 people viewed this question

Ask a Question

Usually answered in minutes!

Top Psi Pressure Washers Experts

John Trevino

Level 3 Expert

1378 Answers

Fordexpert

Level 3 Expert

5331 Answers

Jay Finke
Jay Finke

Level 3 Expert

1222 Answers

Are you a Psi Pressure Washer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...