Question about Carrier 38CKC042 Air Conditioner

2 Answers

Furnace won't turn on

Normal 0 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;} Hi, I have a Carrier Weathermaster 2000 Mod# 58TUA08014 Ser# 3496A08764. It runs fine for awhile but occasionally won't start until I go downstairs and turn the power switch on the side of the furnace off and back on. The problem now is becoming more frequent. It seems to do it most often when the thermostat has cycled cooler all night so the furnace has been off for awhile. I have taken the covers off and checked for loose wiring, etc. and cleaned everything including all electrical contacts. Yesterday I did notice one transformer on the bottom felt hot before I restarted it manually again this morning. Today I checked it while the furnace was operating fine and the same transformer was cool. The transformer is not named on the wiring diagram but is on the right side and has a black & white wire going to it on top and blue & red going to it on the bottom. Any advice? Thanks! Bill Hoidas

Posted by on

  • bhoidas Feb 07, 2009

    thanks but no flame sensor as it's electronic ignition with "glow plug" I don't think the transformer is for the humidifier as it's mounted on the blower housing but I'll check. I just read about the led code on the wiring diagram yesterday so haven't been able to read a code yet when it's "stalled"

    Bill


×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Have you checked to see if the fan motor is getting hot. Sometimes a system will shut down if the fan motor is causing the reset fuse to break the circuit due to heat. If that is the problem just a replacement of the motor will usually fix the problem.

Posted on Mar 11, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 92 Answers

As far as the mystery transformer goes im guessing for humidafier.the furnance is going into lock out line voltage resets this and lets it retry. dont know your level of skills but alot of times this is caused by flame sensor which is part of pilot assembly,metal rod that pilot passes electric signal back to control which confirms pilot lite. lightly sand rod that might get you goin

Posted on Feb 06, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Carrier Furnace won't start up


Sequence of events: call for heat at T-stat, inducer motor turns on, negative pressure created in heat exchanger closes pressure switch, pressure switch control wire runs through all safety's (these must all be in closed/safe position) if ok then glow plug lights. Time delay then gas valve opens, flame verified by "flame rod" t-stat = :)

Apr 22, 2013 | Heating & Cooling

1 Answer

Have a Kenmore Elite Dryer that won't start. Mod 110.65962401 Ser MS0303258 Type DDOT-ELE-2406028-CV54


Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

Aug 22, 2011 | Kenmore Elite HE4 Electric Dryer

1 Answer

I have a Carrier Gas Furnace Model # 395CAV024055ABJA, I works fine if you keep the temp low, like 68, so that it doesnt come on very often, but if you try turning it up and it needs to run for awhile, it...


It sounds like it is going into overheat mode. Check the overheat sensor, make sure the flue is clean, make sure any filters are clean, also check the gas passage inthe heat exchanger, if there is a blockage from soot the system will overheat

Feb 24, 2011 | Carrier Heating & Cooling

1 Answer

Hi, I have a Carrier Weathermaster XS. I don't


If I am correct, that is a gas furnace, right? I believe it may be between 15 and 20 years. Pro-active with and older gas furnace is never a bad thing. First of all it can become a safety issue, as concerns of heat exchangers cracking and leaking carbon monoxide into the home become increasing. Second, it sure only be 80% efficient, whereas a new condensing furnace today can be up to 95% efficient. That means that you currently only use 80% of the gas you are burning as actual heat transferred into the house via airflow, and the other 20% is literally leaving the house through the flue. So you can increase efficiency dramatically and be safe at the same time by replacing pro-actively

Mar 09, 2010 | Heating & Cooling

1 Answer

Carrier furnace clicking/rattling


Hi some thing in the blower motor or combustion fan?

Feb 16, 2010 | Heating & Cooling

1 Answer

How do I reduce the amount of moisture accumulating on my windows


First off run your bathroom fan for at least 1 hour after you take a shower. another thing to do if you have a humidifier is to lower the setting whenever the outside ambient goes down.

Dec 22, 2008 | Heating & Cooling

1 Answer

Carrier Weathermaker won't stay running


Is this a gas furnace if so is it high efficient if so is there an led light on the furnace blinking a code usually seen through a window at the furnace. is the thermostat battery operated if so is it a new battery and are the aif filters new. These would be my first steps to check hope this helps

Dec 21, 2008 | Carrier XHB123D X/Y Series Heat/Cool Air...

1 Answer

Blower runs, Ignitor glows, no 24V at gas valve, no click....


Check the two wires coming directly off the transformer. They will be connected to the board the line voltage will be black and white and the 24voltage will be something like blue and red undo from board and check to see if you have 24 volts there. If not your transformer is bad 10 dollar part. Take it to Heating and Air parts house to replace. Let me know ken

Dec 13, 2008 | Carrier XHB123D X/Y Series Heat/Cool Air...

Not finding what you are looking for?
Carrier 38CKC042 Air Conditioner Logo

1,401 people viewed this question

Ask a Question

Usually answered in minutes!

Top Carrier Heating & Cooling Experts

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

Donni Steen

Level 3 Expert

659 Answers

Bill Long

Level 3 Expert

587 Answers

Are you a Carrier Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...