Question about Sharp R-1870 Convection/Microwave Oven

1 Answer

Our microwave/convecton turns itself off after about a minute

We have a Sharp R1870 microwave/convection oven. While baking today, it turned itself off. The blower still worked, and it produced heat, but everytime I restarted it, it would turn itself off (lights, timer, turntable, etc.) after about a minute.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Sharp Master
  • 8,820 Answers

This is a problem in one of the damper-related components, most likely the switch, but it may also be the motor or the damper door.

The damper is a door inside that opens or closes depending on cooking mode. If the controller senses that the door is not in the right position, it will shut down the cook cycle.

Sharp models stop after 59 seconds.

See the attached sample photo for a typical damper assembly.

We have the applicable service manuals for these models and have uploaded it to our site here and here to help you. You will need the free Adobe Reader to view or print it.

If a switch is all you need, we offer a universal type for only $5 postpaid which you can order here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Posted on Feb 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sharp microwave r1870 only runs for 59 seconds


If it consistently runs for exactly 59 seconds, and shuts off, it's probably the control panel.

If it runs approximately that length of time, you might have a defective thermal protector on the magnetron, or the magnetron is running too warm for some reason.

Mar 24, 2016 | Sharp R-1870 Convection/Microwave Oven

1 Answer

I have a R-9H83 Sharp Carousel II Microwave Convection Oven that I have had for years and now when I use the convection to bake, it only will stay on for a few minutes and then just shut down. Any...


If you use a sensor function, the sensor may be obstructed, please clean the sides and top of your microwave with a dishcloth, warm water, and soap to dislodge any rough or stained spots.
If setting a timer, when setting to bake please pay close attention to the unit of measure so that you set it right, minutes vs. hours as you may leave the oven to do its business and return without noticing it did exactly what you told it to do but you had thought you entered a longer time.

Nov 21, 2013 | Sharp Microwave Ovens

1 Answer

My Sharp Micro Convection Model R1870 fan behind the touch panel keeps running for 50 seconds after the microwave turns off,. this is not the vent fan. it also runs for 50 seconds when you turn the...


If the fan seems to run even after the microwave had completed the cycle, then it is possible that the drive to the fan is having a time delay. Also it has to be made sure that the magnetron has been cut OFF power or else it is not a good situation. You will have to remove the control panel and check on the board, check the drive to the fan, since the processor cuts off the fan and magnetron at the same time the fan circuit must be traced. Look to the circuit after identifying the fan wiring and back check using a multimter if you are able to trace. If not take help as this can be harmful in case the microwave works till the fan cuts off. A faulty capacitor on the board can create this time delay.

Oct 11, 2011 | Sharp R-1870 Convection/Microwave Oven

1 Answer

My sharp R1870 microwave/convestion oven turns


This is a problem in one of the damper-related components, either the switch or motor or the damper door may be binding.

The damper is a door inside that opens or closes depending on cooking mode. If the controller senses that the door is not in the right position, it will shut down the cook cycle.

Sharp models stop after 59 seconds.

See the attached sample drawing for a typical damper assembly.

We have the applicable service manuals for these models and have uploaded it to our site here and here to help you.

If a switch is all you need, we offer a universal type for only $5 postpaid which you can order here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

William E. Miller
prototech@usa.net
http://www.microwavedisplay.com



damper.jpgdamper.jpg

Apr 26, 2010 | Sharp R-1870 Convection/Microwave Oven

1 Answer

The oven/microwave turn off after about a minute


This is a problem in one of the damper-related components, most likely the switch, but it may also be the motor or the damper door.

The damper is a door inside that opens or closes depending on cooking mode. If the controller senses that the door is not in the right position, it will shut down the cook cycle.

Sharp models stop after 59 seconds.

See the attached sample photo for a typical damper assembly.

We have the applicable service manuals for these models and have uploaded it to our site here and here to help you. You will need the free Adobe Reader to view or print it.

If a switch is all you need, we offer a universal type for only $5 postpaid which you can order here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Feb 05, 2009 | Sharp R-1870 Convection/Microwave Oven

Not finding what you are looking for?
Sharp R-1870 Convection/Microwave Oven Logo

Related Topics:

237 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sharp Microwave Ovens Experts

William Miller
William Miller

Level 3 Expert

8820 Answers

Devabhakthuni...
Devabhakthuni...

Level 2 Expert

224 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Sharp Microwave Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...