Question about Whirlpool GS6NBEXR Side by Side Refrigerator

1 Answer

Refrigerator Problems my icemaker is getting water and there is no sign of ice in the bucket or tray....

Posted by on

  • Thomas Malailua
    Thomas Malailua May 11, 2010

    what i would like you to know most is that an ice maker can not make ice with out the frezer working properly.so if temps or funktion of frezer was off one of the first signs of that would be the icemaker not making ice.so with that said,if you frezer is fine and your icemaker has water in it and it is nice and froze,then as long as their is voltage to the icemaker[most of the time that is true ,but as a repairman i would check before doing anything]then the icemaker is at fault and would be replaced to get ice production.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Check to see if there is some sort of interlock mechanism that does not allow ice to be dumped if the door to the freezer is open. I have a side by side and the "switch" got stuck - simulating the door being open... and when that occurs, ice maker gets turned off.

Posted on Feb 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ice maker stopped dispensing


Refrigerator - Icemaker Not Dispensing,or Not Making Ice Check that the feeler arm on the icemaker is in the down position and is not blocked. If the icemaker does not have a feeler arm make sure the icemaker paddle is not blocked under the icemaker. For more information on the causes of new icemakers not making ice. For more information on normal ice production. Side by Side models: The filter may be loaded with sediment that can cause low water pressure. The water pressure must be between 40 and 120 psi. Pressures below 40 psi may cause a malfunction of the icemaker (i.e. producing hollow cubes or no ice production). Test the water pressure: Dispense water from the dispenser into a large measuring cup for 20 seconds. If the measuring cup contains less than 13.5 ounces (400 metric centimeters), the water flow is inadequate. If the amount of water is less than 13.5 ounces then the refrigerator fails the test, remove the filter and test the refrigerator again with the by-pass plug in place. If the refrigerator dispenses the proper amount of water with the by-pass plug in place, then the filter should be replaced. If you no longer have the by-pass plug and it has been over three months since the filter has been replaced, you should replace the filter. If the refrigerator fails the test again and you know you have the proper water pressure in your home, you should call service to check the refrigerator. If the amount of water collected is over 13.5 ounces then the refrigerator passes the test and the dispenser is working correctly. Ice not Dispensing Due To Clumping Ice: Your dispenser may not be dispensing due to clumping ice cubes. The ice cubes in your icemaker may be clumping for a couple of reasons: Low food load: The defrost cycle radiates heat into the freezer. The ice in the freezer will naturally absorb the heat. This will cause the ice to melt slightly during defrost, then eventually freeze together in clumps. Increasing the food load in the freezer will buffer the warmth from the defrost cycle and keeps the ice from melting. Lack of use: When the ice bin is full, the pressure from the weight of the cubes can cause the bottom cubes to fuse and clump. To prevent this from happening, discard the clumped ice and check the bin periodically to ensure the ice is not building up. If you do not use a large amount of ice, move the feeler arm on the icemaker to the up position to turn off the icemaker and stop ice production. For more information on the causes of clumping cubes. If the ice bucket is not seated correctly, ice will not dispense properly. Make sure the ice bucket is in the correct position. Refer to Use & Care manual.

Aug 05, 2012 | Maytag Refrigerators

1 Answer

Stainless Steel GE Profile with Bottom Freezer.


Have you had any cooling problems coincide with the ice problem? if no evidence of temperature variations, you either have a crack in the ice maker mold, causing water to drip into the ice bucket. Or you may have a bad water valve solenoid, not closing completely when the ice maker stops calling for water, overfilling ice maker into the bucket, and further down your freezer.

those are the most common problems, though other odd situations could also be a problem.

Mar 28, 2010 | GE Profile Stainless Bottom-Freezer...

2 Answers

Ice maker leaks or runs over Causing big chunks of ice in the drawer


It's very possible that the water inlet valve isn't cutting off completely. I had that to happen on mine.

Mar 17, 2010 | Amana ATB1832AR Top Freezer Refrigerator

1 Answer

Ice-maker problem


if the water runs constantly when you turn the water on its your valve but if it does it periodacally it probably your icemaker

Apr 29, 2009 | Maytag MSD2756G Side by Side Refrigerator

1 Answer

11 year old amana bottom freezer icemaker drips water when filling tray


as long as the temp in the frz is normal. the i/m could have a bad thermostat that, could be causing it cycling too soon or the tray is leaking water. either way i/m needs to be replaced, sorry

Sep 26, 2008 | Amana ABB1927DE Bottom Freezer...

1 Answer

Hotpoint HSS25GFP icemaker stopped working


are u sure that model # Is right.. DOnt come up in any of my model data bases Seems like u might of got a bad icemaker.. if the water is coming into the icemaker from the water valve.. icemaker has to have power, to do that... all funtions after that would be controled by the iceaker .. The only other thing i can think of is your refrigerator has to be a certain temp to activate icemaker somewhere around 0 give or take some to be safe

Aug 21, 2007 | Hotpoint HSS25GFP Side by Side...

2 Answers

Ice Dispenser Doesn't work...


sounds like the water coming into the icemaker is spilling over or leaking into the ice despenser bucket.... check for ice build up or plugging of water chut into ice maker

Aug 08, 2007 | Whirlpool GS6NBEXR Side by Side...

1 Answer

Side by side fridge / freezer - Icemaker problems


What kind of ice maker do you have? Is it "Ice Maker Plus"? Pull the ice bucket out so you can get a better view. On the back of the freezer is a spout ramp that should connect to the back of the ice tray water deflector that the wire connects to. (I know, It's cold in there). The water deflector is connected to the back of the ice tray which sends the water to the tray. It should snap in.

Jul 06, 2007 | Whirlpool ED2FHSS Side by Side...

2 Answers

Water leaking inside freezer ice maker


sounds like the line was frozen but the water fill indicator is faulty.

Jun 05, 2007 | Hotpoint HSS25GFP Side by Side...

Not finding what you are looking for?
Whirlpool GS6NBEXR Side by Side Refrigerator Logo

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4630 Answers

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Whirlpool Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...