Question about Food Processors

2 Answers

My food processor wont start? - Food Processors

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

Plz contact 022-23051554 \ 23095757

Posted on Feb 03, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a moulinex food processor. OVATIO AT7
I was trying to make some dough for bread but the mixer bowl wont work, but the blender does.
I have double checked that it locked on properly and am baffled because i had used it a couple of days ago, then used the blender then wanted to use the mixer bowl and it wont work. The motor runs but mothing happens.
Marian

Posted on Feb 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cuisinart DLC-7E


First look for a reset button. Then check that the fuse hasn't blown.

Oct 02, 2007 | Food Processors

1 Answer

Mt food processor wont work at all,not start or pulse & its never been used


Food Processor not working. Correct assembly. - YouTube

? 1:07
https://www.youtube.com/watch?v=rFvq71bHqtg
Mar 11, 2015 - Uploaded by Sage Appliances
If your Sage Food Processor won't turn on this clip shows the correct assembly and describes the various ...Missing: mt

KitchenAid KFP0711CU 7 Cup Food Processor, Contour ...



Jan 01, 2016 | Food Processors

1 Answer

Kitchenaid Food processor won't turn on, I was trying to puree steamed vegetables and ground chicken together for my 7 month olds baby food. was working intitially but suddenly stopped and wont start.


The container may have been incorrectly installed in the base or installed but not locked in position. Also, the speed switch may have picked a bad time to fail.

Oct 28, 2014 | KitchenAid KFP0711 Food Processor, 7 Cup

1 Answer

Light comes on wont start


Probably the safety microswitch activated by the bowl mechanism is not being pushed in far enough. Most likely it will need a new bowl or lid.

Apr 25, 2012 | KitchenAid KFP450 Ultra Power 7 Cups Food...

1 Answer

I have a small Cuisinart food processor and I cannot figure out how to turn it on. It has two levers low and high. I have it plugged in and the lid on? Please help. Fiona Slattery 858-752-8591


Hi,

Your PowerBlend Duet™ comes with a food processor button. This button is the perfect speed for all your food processing tasks. Always use this speed when using the food processor. You may also use the Pulse button with this function for pulse-chopping.
To use your food processor, make sure that the bowl is assembled properly and the blade or slicing/shredding disc and the cover are locked into place.
When you use the control panel, the LED will light next to each button you press.
Press the On button. For continuous operation, press the Food Processor button. Motor will start if you have followed assembly instructions.
To turn motor off, press the Food Processor button again or the Off button.
For on/off operation, called pulse-chopping or pulsing, press the On button, press the Pulse button, and then press and release the
Food Processor button the desired number of times. Motor runs as long as you hold the Food Processor button down. The motor stops when you release control switch. Try it a few times.
You control the duration and frequency of pulses by the length of time you hold the Food Processor button down and the rate at which you press it. Pulses should be short bursts. Allow enough time between pulses to let food in work bowl fall to bottom.
Always use the Food Processor button for pulse/chopping. Never turn cover back and forth to start and stop processor.

You can download manual from the below link

http://www.cuisinart.com/share/pdf/manuals/bfp-10ch.pdf

ENJOY! RATE THIS SOLUTION
RNJ VINOD KUMAR

Sep 12, 2009 | Cuisinart Food Processors

1 Answer

Cuisinart 7 cup food processor wont' start


Remove the work bowl completely. Turn the machine on and use a pen to depress the dark grey or black button on the base of the food processor. If the motor doesn't spin, it needs repair. If there is spinning:
Make sure the handle of the bowl is facing the front of the food processor. Place the lid tab just to the left of the handle and slide it toward the handle until it won't turn anymore. Remove the pusher sleeve from the lid and reinsert it with the lock facing the front of the food processor. Slide the lock into the locked psoition. If it still doesn't work, replace the third piece on the work bowl - the one piece that you haven't replaced. It will then work.

-Tha Mp3 Doctor

Jan 06, 2009 | Cuisinart DLC-5 Food Processor

1 Answer

I can't get my food processor (DLC-2007N) to start. It looks like everything is locked in place, and the light goes on, but the motor won't start.


Remove the work bowl from the base of the food processor, and separate the bowl, lid, and pusher sleeve.
Plug the base into the wall outlet, turn the food processor ON, and then use a pen to press in the dark grey or black button on top of the base of the food processor - if you hear some kind of noise, then your motor is still good.
Put the work bowl on first, with the handle facing the front of the food processor.
Put the lid on, with the lid lined up with the handle of the work bowl.
Put the pusher sleeve in the lid, with the metal piece facing the front of the processor.
Your processor should now turn on.

If it doesn't call Cuisinart and see if you are still in-warranty (3-year warranty).

Good luck!

-Tha Mp3 Doctor (also loves Cuisinart)

Aug 31, 2008 | Cuisinart DLC-2007 7 Cups Food Processor

1 Answer

Food processor stopped working


hi there is no reset switch follow these instructions and it suppose to work http://www.useandcaremanuals.com/pdf/FP1300-1400Series791.pdf when you used it did you smell a burned stench? is the unit smells still from it? then probebly the coiles are burend - sorry cant help.... http://www.blackanddeckerappliances.com/customercare/home.jsp good luck

Mar 21, 2006 | Black & Decker FP1300 Quick N Easy Food...

Not finding what you are looking for?
Food Processors Logo

Related Topics:

492 people viewed this question

Ask a Question

Usually answered in minutes!

Top Food Processors Experts

Ryan S
Ryan S

Level 2 Expert

328 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

clay_pots_47
clay_pots_47

Level 1 Expert

7 Answers

Are you a Food Processor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...