Question about Whirlpool Cabrio WTW6600SBT Top Load Washer
Washer stops and shows F1 error code; manual just says call repair man; after changing settings, and pausing on/off a few times it restarts. we've had the washer for about 2 years before this started. Looking on line it appears this is very common with this product. Is there anything that can be done or just call whirlpool? I have the same problem, but my seriel # is WTW 6300swd and it is the Cabrio top loading washer and the F1 comes up all the time! Does this one fall under the recall also?
CALL 18002531301 AND TELL THEM YOU HAVE THE F 1 CODE PROBLEM. THEY HAVEN'T CALLED THIS A RECALL, BUT THEY ARE CALLING IT A CUSTOMER AWARENESS PROBLEM.
WHIRLPOOL IS SENDING TECHNICIANS OUT NEXT DAY FREE OF CHARGE.
Posted on Feb 04, 2009
SOURCE: F1 error code on cabrio washer
The F1 error code on this washer indicates a Primary Control Board failure.
It is likely that the machine control board will need to be replaced to correct this problem.
The part number for the machine control board is undetermineable because you have not provided me with the exact model # of your washer.
The procedure for replacing the machine control board is provided HERE
NOTE: Be sure to unplug the washer to disconnect electrical power before accessing internal components.
There is a slight possibility that a problem with the pressure switch hose could be causing this problem.
A pinched or twisted air hose can cause this fault code.
When you open the console, check the air hose connected to the pressure switch on the machine control board.
If it is pinched or crimped, I recommend rerouting the hose to resolve this problem.
This may fix your problem without replacing the control board.
NOTE: You may want to check for this condition before ordering the control board. Most electronic control boards cannot be returned for a refund or credit.
If you find no apparent problems with the air hose on the pressure switch, then replacing the machine control board on this washer should correct your problem. There is a risk involved in replacing this part yourself.
As noted above, you could have a problem with the air pressure hose that is not apparent upon your initial inspection. A service technician would normally need to properly and thoroughly diagnose this problem before replacing the control board.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for helping with your FREE question
Posted on Sep 14, 2010
Tips for a great answer:
May 04, 2016 | Whirlpool WTW8200YW Cabrio Top Load Washer
Oct 18, 2014 | Whirlpool Washing Machines
Jan 18, 2014 | Whirlpool Cabrio WTW6600SBT Top Load...
Aug 03, 2010 | Kenmore Oasis HE 27082 Top Load Washer
Jul 25, 2010 | Whirlpool Cabrio WTW6600SBT Top Load...
Nov 25, 2009 | Whirlpool Cabrio WTW6600SBT Top Load...
Feb 02, 2009 | Washing Machines
817 people viewed this question
Usually answered in minutes!