My run lights dont trun on

You dont have a fuse blown, You dont have a good connection at the wire plug or a broken wire on the trailer

robersglenn did your solve this problem, I have the exact same symptoms. Please post the solution. Thank you. tom

have u check fuse the run on same

i just recently replaced my brake lights and running lights

are you sure you wired everything correctly?
check again especially your grounds

the trun signal and brake light are on the same bulb or element the running light is in a different bulb single element some cars have three bulbs with one element and they are 1157 1156 and so on.

Sounds like you could be having an issue with the onboard electronics. With as much "computer" controlled items and systems on the vehicles now adays. I would have to say your best shot is to take it into a repair shop and have them hook their system up and see if something hasn't gotten scrambled in the system. Or it could end up being that a wireing harness or connection may be lose and causing issues with the entire system.

sound like you have a bad sencer or relay. you can run a wire from the fan . to a wire that run on when the car start and trun off when you trun the car off.that will get you by for a short time good luck

Make sure that ypur parking brake is completely released because if it is engaged even slightly the daytime lights will trun off. If that's not the problem then check the bulbs.

i spliced a wire from the tail light running light to the trailer light connection assem. where all the running lights were connected

Pull instrument/ cluster panel and re-melt cold solder joints where circuit board connects to dash connectors. Get them hot enough to turn them bright silver, usually 3-5 seconds each pin.
Good Luck!