Problem connecting my linksys WRT160N to pc.

go to this website
http://homesupport.cisco.com/en-us/wireless/lbc/WRT160N

click the downloads tab
select the harware version of your router
download the setup wizard

connect the modem to the valet ( internet port )
connect the computer to the # 1 port of the valet
run the setup wizard

Yes, Linksys WRT160N is 100% compatible with ADSL2. Linksys WRT160N is a Broadband router.

you will not be able to use the linksys WRT160N, as an ADSL2 modem router. you should be using an ADSL2 Modem separately and connect the cable from the modem to the Linksys WRT160N. Hope this clarify the doubt.

Hi, it should do, have you got it connected up properly.
Phone into modem
Router into modem
pc into router
Turn each of these in order as above and wait a minute for each.
let me know what happens.

No need ti install cd for router
steps
1,connect router to isp provider connection
2,connect network cable from the laptop/pc to router
type ip address of the router on the computer browser
eg:192.168.1.1
username:admin
password: admin or admin12
configure the router by the help of isp provider

hi it is very simple. you dont need set up disc to install a router.
You can try this web site
Click Here

Get Network Magic ... download for evaluation.

This is a tremendous network management tool well worth the $. If you dont pay, you can still use most features.

Get it and use it to get your connection going at least.

Let me know what happens

a

Hi! I will be more than glad to assist u in this concern..That is right! if u bypass the router it will work, the reason why the modem wont talk to the router bcoz the router is not properly setup.. if you are using a cable modem from ur cable company provider- u need to do a mac clone on the router ,u have to clone the mac address of ur dell desktop computer which works with the local cable company... normaly the mac of ur computer is the one register to your cable company and on the setup page of the router just select on the internet setup, dhcp after clonning the mac address of your computer. u need to connect ur computer directly to the router and then after doing the process connect the router to the modem.

Check the Ethernet adapter status under network adapters in devicemanager.

right click my computer-properties-hardware tab-device manager-network adapter.etherrnet should be green

You must first connect your printer to the pc using usb cable, then run installation wizard that is on the CD that came with the printer.

Wizard will guide you through the setup orcess where you will provider your routers ssid (linksys) to your printer, and your printer will use that ssid to connect to your router.

After the Wizard setup is done, it will tell you to disconnect the usb cable and only then your printer will work on wireless.

Good luck,
Milan

On which port of the D-link router did you plug the WRT160N router?

Do this setup.

Disconnect the WRT160N from D-link.

Connect a computer to port 1 of the WRT160N. Access the setup page by typing 192.168.1.1 on the address bar. you may need to type in the username and password for WRT160N. on the setup page Change the LAN IP address from 192.168.1.1 to 192.168.2.1. save the settings.

Connect a cable from port 1,2,3 or 4 of the D-link router to the Internet port of the WRT160N. turn off everything then turn them on starting from cable modem>D-link >WRT160N then computer.

You should be able to access the internet.