Re: I need antitheft security code for my factory fitted...
If you go to any authorized jeep dealer you can typically get the code with little more than the vehicles registration. If the vehicle was purchased from a used lot they may or may not have access to the codes. The jeep dealer will most likely charge a service fee. Good luck, hope this helps.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
My suggestion would be to buy a wiring harness and a dash mounting kit. After that unscrew or pull out the console/dash part thats around your factory deck. Then unscrew the bolts/screws holding the factory one in place. Remove it. Plug the wiring harness into the factory wire plug. Pull harness wires through the mounting kit. Attach the corresponding colored wires from the harness to your new deck. Slide your deck into the mounting kit and secure it in place. Most decks have little prongs that you can pry up to **** up against the mounting kit so it wont slide out without pushing those down (makes it more secure and harder to steal). Place deck with mounting kit into area factory deck was. Put the screws/bolts back into place tightly. Place console/dash part back on. You will need the mounting kit (99% of new decks are smaller than the factory). Wiring harness is optional but recommended.
With the newer cars most radios have a theft deterrent device built into the radio, and if they steal your system it will not work in another jeep/car the dealer knows the unlock code, some charge to unlock the radio some don't.
That's why when doing electrical work on a car/truck etc. You have to have 12V DC power to the battery terminals all the time or you will loose the code and then only the dealer can help you unlock the radio. HTH.
Have someone get behind you and see if they can smell rotten eggs. It could be the 02 sensor going bad. Is the check engine light coming on? Also try to change the fuel filters. There should be two. One by the fuel tank and one on the firewall. They are very inexpensive and could be the cause of all the trouble. If that doesn't work, I would suggest hauling it off to the car crusher.