Whirlpool duet frontloading washer been washing clothes all day just went to check clothes and its flashing F35 and the door lock wont open even after I push the button to cancel it locking help

Press the cancel button twice to cancel the error code. There should be an error code flashing -- for example 'F02'.

Here's two links on the SUD error on a Whirlpool Duet--pretty common with these newer front load washers--try less soap, try different soap, check the pressure switch.....

http://www.managemylife.com/mmh/questions/148082-what-is-causing-f02-and-sud-to-display-on-my-whirlpool-duet-washer

http://www.managemylife.com/mmh/questions/151612-why-does-my-whirlpool-duet-washer-flash-an-sud-message-followed-by-a-f35-code

Check your washer plug to see if the connections are tightly screwed. Next check your filter if you haven't for long.

Remove the 3 screws at the bottom of the front panel under the washer door. Your filter door will be light brown. If you find a hose there it is to drain out excess water (water that could not be drained by your pump) After you hv drained unscrew the cap and remove all the junk inside. Have a large plastic bag to catch junk and water. Refit carefully after cleaning out. If not solved, something shd be blocking your pump, check this out

How abt a nice rating for the free help? Thnks

Remove the service panel and see if the filter has something in it

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

I;ve had the same problem (SUD on first fill) and found this most helpful for my WFW9600TW01 Duet washer

http://www.tellingmachine.com/post/Fixing-Sud-and-F35-errors-on-my-Whirlpool-WFW9600TW01-Washer.aspx

I duplicated his actions and it cleared up my SUD/F35 error. I think running the diagnostic test multiple times flushes the sensors/sensing lines to eliminate the problem.

Change the pressure switch or blow the hose for restriction But enerally this is a faulty pressure switch

https://secured.whirlpool.com/Service/SrvTechAdm.nsf/2cd44500d572193285256a45004fd9d6/6545d78b3f479480852571650061b1ba/$FILE/8178558.pdf CLEAN OUT THE TRAP..SEE PICS

Press and hold "end of cycle" button for 3 seconds, on the right side of panel. Wait for 2 minutes before trying the door. This is the child lock feature, do it again & it locks.

If helped, pl rate me good!!

F35

ANALOG PRESSURE SENSOR FAILURE

If this failure is displayed, there is any malfunction of the steamer
component detected by the Steamer Electronic Board.


Possible Causes/Procedure

1. Check if pressure hose is fixed correctly.
2. Check if the airtrap is not blocked.
3. Check if the hose is not blocked.
Check these problems.
Plesae leave a solved rating before you leave the site

I had similar problem, the front door seal can trap small items,socks,handtowels. I didnt figure this out for some months, each load of clothes had a foul, mildew smell, Check door seal for trapped clothes, run intermittent cycles with bleach only, no clothes, be sure to leave door open when not in use to air out , this will reduce smell.