Question about Asko W6021 Front Load Washer

1 Answer

Operation manual I would like to obtain an operators manual or a copy of one for the Asko 10504 washing machine. This is quite an old machine but still going strong. The original Manual has been lost. Where might I be able to download a copy of purchase one? Kind regards Neil Abbott

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Http://safemanuals.com/user-guide-instructions-owner-manual/ASKO/10504-_E

I think this web site has a PDF of your manual. If not try to googe ASKO 10504 washer manual

good luck

Posted on Feb 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Asko 10504 has started making what sounds like a metal on metal grinding sound when it spins. It's as if the whole drum assembly is moving more than it should and coming into contact with something,...


COULD BE THE TRANSMISSION SPRING OR TRANSMISSION BEARINGS. EVEN UR TUB BEARINGS IN THE TUB, A BAD MOTOR COUPLER HOWEVER U WOULD NOT GET ANY SPIN OR AGITATION IF THE COUPLER WAS BAD. BAD BREAKING SYSTEM WOULD NORMALLY MAKE NOISE BUT WHAT U WOULD GET THEN IS A COMBINED SPIN AND AGITATION DURING SPIN CYCLE,

Mar 23, 2015 | Asko Washing Machines

1 Answer

I have an asco 10504 washing machine. Very shortly after it starts the washing cycle it goes in to a fast spin. If I turn the power off and on a few times it eventually starts washing properly. This has...


Hi, Welcome to FixYa. Before I can accurately help diagnos the problem with your Asko 10504 I need to ask a few questions. Does the unit go directly into this spin with or without draining ? Does this occur regardless of cycle selection ? I will watch for your reply, please be patient if I don't respond immediately as we may be in different time zones as well as I am often working hands on repairs as I try to answer here at FixYa. Regards, Macmarkus :)

Sep 08, 2010 | Washing Machines

1 Answer

Lost manual


yes directly from asko online

May 16, 2010 | Asko W6221 Front Load Washer

2 Answers

How to use thomson washing machine tx 708


I misplaced the manual of my Thomson TX829, please can you advise where I can obtain a new copy.

Jan 15, 2010 | Thomson Washing Machines

2 Answers

Drum will not spin


Hi,
I am the new owner of a used Asko Cylinda 10504.
The last owner briefly demonstrated the washer starting a wash cycle and entering the agitation cycle of the wash before stopping and pumping the water out and spinning in a final end cycle. I bought it. I had the machine installed turned it on and cannot get it to go through the wash cycle. After starting at #1 it goes through a perpetual spin cycle of sorts--water and soap soaking the drum and laundry but not enough water to fill up half way or less. It stops at number 4 on the program knob sits on a red dot (next to the #4) and does nothing. I then manually move it to the next cycle and it repeats the spin cycle again until I have advanced the program to the end. No wash cycle no rinse cycle. Nothing. When it advances to the red dot I wait for at least 5 minutes before manually advancing the knob. The instructions say that I should get the water pumped out by turning the program knob to #7 or #9 but in both cases it just spins and does no empty or finish in the end spin cycle of several (9?) minutes. Nothing but banging and spinning. The water seems to get into the drum as well as the detergent but nothing else is happening.
No mater where I start the program it spins and sloshes soapy water, pumping almost nothing out.
Any suggestions short of putting it on the curb or paying a kings ransom to fly a tech out to look at it?

MY GUESS.
It seems that it is repeating the same brief cycle over and over. During the move to my house the electronics re set(??!?!?) and now need to be set to the normal mode after being re connected?
Can you help?
Blessings,
Douglas

May 20, 2009 | Asko Washing Machines

1 Answer

ASKO washer WL6511XXLPP


Purchased ASKO Washer WL6511XXLP and Gas Dryer with pedestals, 12/01/09. It threw a drum paddle during 2nd. wash cycle. Damaged several articles of clothing.
ASKO replaced the paddle 2/19/09 after a lot of phone calls (lip service from the ASKO 800 #). They claimed the part had to come from Sweden (reason for delay).
Washer threw another drum paddle during 4th. wash cycle. Damaged several more articles of clothing. We have made no claim for the damaged clothing, the retailer has been cooperative.

ASKO has promised to replace the washer after the retailer we purchased the washer from, strongly encouraged them to do so. We are still without a washer (03/23/09). My wife and I are retired, I am 76. Point being; we do not abuse washing machines and we don't like going to a launder-mat.
I know this is not the venue to address this problem, but am at my wits end.

Mar 22, 2009 | Asko WL6511W Front Load Washer

1 Answer

Motor not running in Asko 10504 washing machine


The motor might have burned out. Another possibility would be a partially fried control board.

Jan 17, 2009 | Asko Washing Machines

2 Answers

Asea (Asko) Cylinda 12000 Washing Machine Spin Problem


No reset. Carbon brushes are worrn out. Consider changing the bearings while you have the motor apart. Se http://www.nettoparts.co.uk/shop/frontpage.html for spares.
Best regards, Dag Gulbrandsen, Norway

Apr 02, 2008 | Asko Washing Machines

Not finding what you are looking for?
Asko W6021 Front Load Washer Logo

Related Topics:

597 people viewed this question

Ask a Question

Usually answered in minutes!

Top Asko Washing Machines Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3051 Answers

Are you an Asko Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...