Wii remote will not follow command.
It's problem a radio interference, since the wii controller uses radio frequences to contact the device, try to resync the wii controller.
1. Turn the Wii console on and wait until the "Health & Safety" screen appears (don't press A).
Open the SD Card slot cover on the front of the Wii console, just below
the disc drive, and press and hold the red SYNC button for 15 seconds.
This will clear all synced Wii Remotes from the console.
Resync the Wii Remote by removing the battery cover and pressing the
red "SYNC" button. Do this for all Wii Remotes you wish to use, and
test for proper response.
4. If the steps above do not work,
remove the batteries of the Wii Remote and leave them out for at least
2 or 3 minutes. Reinsert the batteries and sync the Wii Remote again.
Test for proper response.
If after removing the batteries for several minutes, and resyncing
the Wii Remote, your still unable to get the Wii Remotes to work, try
syncing another Wii Remote if available.
* If another Wii Remote works, then your previous Wii Remote will need to be repaired.
Feb 09, 2009 |
Nintendo Wii Console