Question about Philips HTS-3555 System

1 Answer

No Power I have a power problem with this unit(Wharfedale dvd65st).When i plug it in and turn it on @ the back of the unit and in the front it does not come on i`ve check the fuses and all of them are still alright non have blowen the power swith is still working what els can be wrong????

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 51 Answers

Hai,
Yes, you have checked the fuse but there is no defect right.....!!!!!!!
Please check the power section some time if there is any problem means it will not turn on, i mean to say that inside the dvd player power section.



Posted on Mar 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My rx 675 wont turn on. the red stand by light flashes and that is it.


Try holding the 'tone control' and 'info' buttons and pressing power. This should allow the unit to turn on. See what the front display says at that point. I tshould show some kind of protect code. If the unit turns on and stays on normally after that, then you may have had a temporary problem that was cleared by disconnecting everything. If it turns back off right away, then you will have to get it repaired as something internal has been damaged.

Jan 03, 2015 | Yamaha Home Theater Systems

1 Answer

Bose


For a Wave radio: unplug the power cord, wait a minute, and plug it back in. The display will read "Ejecting CD." If it does so successfully you're good to go.

If not, you'll have to remove the bottom of the unit. Unplug it, turn it upside down with the front facing you, remove 5 screws. Then lift the front of the bottom plate no more than 2" to avoid damaging the wires inside. Reach in and tilt up the CD player's metal housing just enough to be able to grasp the edges of the CD and pull it out. Reassemble the unit.

May 22, 2014 | Home Theater Systems

1 Answer

My Sound Space12 powers on but there's no display and no manual or remote functions to operate the discs or the other functions.Can you provide a answer.regards


If the system is connected properly and the main tuner power is on you will see the orange standby light on in the front of the main diamond shaped control unit. If that light is not on, you have not connected the system and power cables properly.

If the standby light is not lit, press the power on/off button in the middle of the rectangular processor/tuner to turn it off and unplug the main power cord from the main tuner/processor from the wall. Next, ensure that all of the power, video and audio cables from the diamond shaped control unit are properly connected to the large tuner/processor. Since you are there, check any other av in/out connections.

Now that you have checked and adjusted the cables between the controller and the tuner, plug the tuner back into the wall and push the power on button. Now check the standby light again on the diamond shaped controller unit.

Once that light is lit, press the silver, horizontal on button in the middle of the diamond shaped display unit, or the Power Standby/On button on your main remote control and you are operational.

Mar 05, 2011 | Nakamichi SoundSpace 12 System

1 Answer

My Panasonic SC-HT995W keeps on flashing W and the rear speakers wont work. Ive tried turning off all other wireless devices but it still persists


I had exactly the same problem. My unit worked fine until a loose power cable resulted in the receiver being turned on and off a couple of times in quick succession and then after this the a/c in light on the rear speaker was lit but the wireless link light would not come on (and the 'W' on the main unit flashed constantly). The solution for me was basically a reboot. This is what I did;
- unplug the wireless receiver
- unplug the main unit
- remove the digital transceiver unit from its slot in the back of the main unit
- plug the main unit back in and turn it on - the 'W' won't flash as the transceiver has been removed (not sure if you if it's necessary but I made sure it was producing sound to the front speakers)
- unplug the main unit again
- reinsert the digital transceiver
- plug the main unit back in, turn it on and set it to produce output/sound (the 'W' will be flashing)
- then plug the wireless receiver back in again
...presto the link is made, the 'W' stops flashing and the rear speakers work again.

Hope this elaborate reboot works as well for you as it did for me.

Aug 08, 2010 | Panasonic SC-HT995W System

1 Answer

My color picture is gone and it is only black and white??


unplug the unit.wait a minute or two and plug it back in.turn power back ON.
Remove HDMI cable from the TV unit if you have one. Then plug it back in.
Or reset the unit to factory settings. Try these steps.

Jun 25, 2010 | JVC TH-C30 System

1 Answer

Power goes off


Try resetting the unit.
Make sure there is no disc in the unit. With the unit on, go to the front panel and look for the STOP (square) button.
Hold it down until the unit shuts off by itself. Turn it back on it shoudl work fine.

Jul 01, 2009 | Samsung HT-X40 System

1 Answer

I just purchased a RCA model # RTD315w watched only two movies and now the unit wont respond to anything. Still have a movie in the unit that Icant get out because the unit will perform no function. I...


Possible solution that is not mentioned by customer service- is just a small thing- unplug unit- let rest for 30 mins, HOLD POWER BUTTON DOWN FIRST THEN PLUG BACK IN- hold for 30 secs, unplug for 30, the plug back in.

Mar 16, 2009 | Home Theater Systems

1 Answer

Power issues: will not turn off or function


Unplug all of the speakers and power on.Its possible that one of the speakers is causing the protection circuit to activate.If powered on and subwoofer works start reconnecting one speaker at a time( after powered off) and retest each time.One Speaker may be bad.Its also possible the output ic is failing under a speaker load.There are no fuses related to this issue.If its not a speaker problem then the subwoofer will need to be serviced.

Feb 24, 2008 | Panasonic SC-HT730 System

1 Answer

Panasonic SC-HT900 Audio problems


http://www.datasheet.in/search.php

Sep 06, 2006 | Panasonic SC-HT900 System

6 Answers

Unit will not power on, has the standby light on


I took your advice I unpluged the unit then held the power button in then pluged it back into power outlet the unit came on. There is one thing I might add I had to do it twice before the unit came on. Now how long will it work? Who knows

Jun 06, 2006 | RCA RT2500 System

Not finding what you are looking for?
Philips HTS-3555 System Logo

Related Topics:

282 people viewed this question

Ask a Question

Usually answered in minutes!

Top Philips Home Theater Systems Experts

Gyula Lacz

Level 3 Expert

482 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

kakima

Level 3 Expert

96396 Answers

Are you a Philips Home Theater System Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...