Question about Saeco Odea Go

1 Answer

My Saeco Odea Go only produces weak coffee (like water). Tried adjusting the grinder and also different coffee beans. Any ideas?

Posted by on

  • Emma Jan 26, 2013

    The coffee is like dirty water in its colour and has little or no 'creama' froth on top. Any recommendations would be appreciated.

  • Emma Jan 29, 2013

    thank you - but yes, we have tried that too ;)

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 109 Answers

Have you tried adjust coffee strenght?
This is the bean symbol on the bottom of the front control

Posted on Jan 27, 2013

  • Emma Jan 29, 2013

    Thanks, we have tried, but this doesn't work either. Think we are going to have to bite the bullet and get it serviced...

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 74 Answers

SOURCE: saeco odea go

When the grinder stops to work i would turn the grinder to more coarse. this might help if the case is that it has gotten clogged.

Posted on Jul 11, 2008

EsWorld
  • 1618 Answers

SOURCE: No coffee brewing with beans, but with coffee brewing with ground coffee.

It is possible that the grinds chute is blocked, remove the brew unit and check the chute from the grinder chamber, make sure that it is not blocked with coffee grounds.

Posted on May 31, 2009

bozcro
  • 867 Answers

SOURCE: poured water into coffee grinder

easiest thing to do is put it outside to dry or use a blow drier to dry it up, it should be ok

Posted on Jul 01, 2009

EsWorld
  • 1618 Answers

SOURCE: Hi i have a grinder problem with my Saeco Odea Go

Try this remove all the beans using a vac cleaner, then turn to lowest-finest number, then remove screws on grinder lift chamber and turn knob to coarsest setting and reassemble and try machine, remember to adjust grind when machine is grinding.

Posted on Sep 17, 2009

  • 81 Answers

SOURCE: the bean grinder doesnt grind, only water comes out

If it is working before, probably the coffee chute is clogged up. You can remove the bean hopper and see where the coffee drop into the brew unit.If the chute is still attached just clean the blockage, if it is broken you will have to remove the grinder and replaced it.

Posted on Jan 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Saeco Odea Go coffee machine grinder screw rotates with on beans but does not rotate when beans are added. Motor sounds like its working.


There are different possibilities for your problem. First the motor might be damaged and is more weak than before that is why is stop when it need to grind beans. In this case only with replacement motor can solve the problem.

Second probably due to long use of oily coffee or low quality coffee beans or other reason there are coffee grounded in the grinder that become like rubber and does not leave the new coffee to pass through grinding burrs. For this either you have to dismantle the whole grinder and its burrs and clean them with brush or you can use a new magic product that you can fin in eBay it can clean automatically the grinder in 30 second see it at the link

http://www.ebay.com/itm/PULY-GRIND-COFFEE-GRINDER-CLEANER-CRYSTALS-20-GRAMS-PACK-OF-3-PACKETS-/131031511160?ssPageName=STRK:MESE:IT


You can try the above fist and you may solve the problem in minutes if not then you can proceed with the replacement of the ginder burrs or motor.

Jan 10, 2015 | Saeco Odea Go

1 Answer

My Odea Giro stops working when entering the brew pump cycle. When I run it without coffee it runs fine. When I add coffee it stops after the grind cycle. I have replaced the microswitches and cleaned the...


I had a similar problem
Mine was caused by an "oily" type of coffee beans. Grind was accumulating in the grinder.

I did open the machine and cleaned the grinder physically. At least, try to remove all beans and sucked with a vacuum the interior of the grinder screw.

Good luck

Jun 18, 2014 | Saeco Odea Giro Plus Coffee Maker

1 Answer

Saeco odea grinder turns but no grounds


The exit from the grinter to the grup it is blocked.There is a plastic tupe that it is probably broken.To clean that tube and exit you must unscrew the machine and remove the top side of the grinter.

Apr 02, 2014 | Saeco Odea Go

1 Answer

Saeco grinder


Maybe the piece that direct cofee to brew group it is missing, so all cofee fall down.

Oct 04, 2013 | Coffee Makers & Espresso Machines

1 Answer

Hi i have a Saeco Odea Giro Plus, that was broken ceramic baked klay. after replace new it have a problem with my Saeco Odea Giro. The problem is that the bean grinder doesnt grind (I only hear sound of...


Hi,
you need to change this part ,which is under the ceramic knife. You will have to open the coffee grinder and take out the knives and change the holder to the lower knife. That's your problem. This is the product code 149198350

Apr 22, 2017 | Saeco Odea-Giro Espresso Machine

1 Answer

Grinder problem


try to check the brew group

Jun 18, 2012 | Saeco Odea Giro Plus Coffee Maker

1 Answer

The bean grinder doesnt grind, only water comes out


If it is working before, probably the coffee chute is clogged up. You can remove the bean hopper and see where the coffee drop into the brew unit.If the chute is still attached just clean the blockage, if it is broken you will have to remove the grinder and replaced it.

Jan 17, 2010 | Saeco Odea-Giro Espresso Machine

1 Answer

Hi i have a grinder problem with my Saeco Odea Go


Try this remove all the beans using a vac cleaner, then turn to lowest-finest number, then remove screws on grinder lift chamber and turn knob to coarsest setting and reassemble and try machine, remember to adjust grind when machine is grinding.

Sep 10, 2009 | Saeco Odea-Giro Espresso Machine

2 Answers

SUP021 YR keeps getting clogged


go to espressotec logo there you find how you can clean grinder.if still you dont have coffee try explain better whats hapend with machine when you want make espresso,good luck

Sep 04, 2009 | Starbucks Saeco Italia Digital Barista...

3 Answers

Saeco odea go


Try to use another brand and more dry coffee.

Apr 10, 2008 | Saeco Odea Go

Not finding what you are looking for?

Open Questions:

See all Saeco Odea Go Questions

Saeco Odea Go Logo

625 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saeco Coffee Makers & Espresso Machines Experts

espressofixr

Level 1 Expert

16 Answers

83bj60

Level 1 Expert

22 Answers

Shehu Pro
Shehu Pro

Level 3 Expert

1284 Answers

Are you a Saeco Coffee Maker and Espresso Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...