Door closes perfect but door lock light doesent come on .turns back off after about a min

Probably a fault with the lock or latch; should be no problem for an engineer to fix. Just try giving the door a firm push to close it, to see if the padlock light comes on.

Hello Shawn Leonard - Try resetting the unit at the household circuit breaker first and then retry the unit. If this proves to not be successful, then typically this is something that a professional would need to diagnose. Possible causes could be a faulty power cord or house wiring, defective control board, thermal limiter or door switch.

Hi, try opening the door and looking for a little black switch on the right or left side, that the door actuates this is the door switch, while the stove is plugged in, hold this switch in and see if the lock moves.



Sean

techbuster

• Rank: Guru
• Rating: 92%, 2877 Votes

1. Crack open door
2. Within 3 seconds push Hi-Temp Scrub, Heat Dry, Hi-Temp Scrub, Heat Dry
3. Close and latch door
4. Press Cance

Try the above steps and also check the video in link given below to know detailed explantion on what the light means

http://www.youtube.com/watch?v=Hv7xOaucH7I

A poor solder connection on B+ is the line, Horizontal drive transformer or at the base of Horizontal Output transistor can caused that. Re-soldering these section can fix it..

I have a Sony Trinitron 32 color tv KV 2168MTJ (quite old - 10 yrs old), and the standby light blinks exactly 200 times (just over 3 mins) before it turns on. Once it is on, it works perfectly. What's wrong with it and how can i fix it?

Renee, after you hit your wash cycle selection does the washer begin to fill with water and rotate the wash basket? I need to know what does work , it will tell me what does not. capnhook

Sounds like the timing unit which automatically turns off your dome lights after a few minutes is working backwards. Probably need a new unit.

Hi, Does the door lock? Usually when you close the door it locks and allows the water to fill, then it starts the wash cycle. If when you close the door it does not fill, then it could be the door interlock which is at fault. Tom.

Hello, This depends on how old your machine is mine is now 7 years old so I do not want to invest in long term soltions. So I repaired my own, I bought a new interlock and replaced the old one that did not work. So I shorted out the three links that go to the interlock, the machine now shows the lock is always on and you can open the door during the wash cycle so BEWARE. Also if you have never wired a plug or fixed basic electrics DO NOT DO THIS. 1. Turn off power and unplug. (Very Important) 2. Remove lid you will need torx drivers. 3. Unscrew door interlock from the front of the machine. 4. Lift out interlock. Try replacing the interlock with spare first (about £15). 5. If new interlock does not work do the following. 6. Put Interlock back on without wires attched to it. 7. From car spares shop buy spade conectors and create a three way shorting link (insulate well). 8. Put shorting link into each of the wires that go to interlock. Safely tie up wire to a loom (do not let dangle) 9. Shut the door remove hands and try starting the machine. 10. If that works put the machine back together. And warn people that the DOOR CAN BE OPENED DURING WASH CYCLE and STARTED WITH DOOR OPEN. So check when the machine has stopped properly.