Question about Samsung Televison & Video

1 Answer

Ue26d4003bw only comes on after few atttempts

When switching on it keep going into standby,comes on after few attempts. and stays on.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Samsung Master
  • 74,136 Answers

Check whether any capacitors in the main power regulator board bulged. If found such, replace them and check. If not, replace the main power regulator board as card basis. Check the ON/Off switch too for damage.

Posted on Jan 24, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tv keeps switching to standby


Main digital board fault. Check and replace it. If you wish to get more details visit the site linked here. http://electronicshelponline.blogspot.com/

Feb 17, 2017 | Televison & Video

1 Answer

A TV which cannot be turned on as the standby light keeps disappearing when TV goes 'dead'?


Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
http://electro-medical.blogspot.com/
http://electronicshelponline.blogspot.com/
In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.

Jan 16, 2016 | Televison & Video

1 Answer

PDP-4340HD keeps turning off.


Continuous blinks of standby light indicates a fault in the IIC data bus. The main board is likely to be faulty. If you wish to know more Check this link.

Feb 03, 2013 | Pioneer PureVision PDP-4340HD 43 in....

1 Answer

Sony KDL-46z4100 standby light blinking 12 time with few seconds gap continiously


12 blinks of standby light indicates 'Scanrate error'. You must have thorough knowledge in electronics to proceed. Actually, this is not a user repairable fault. it is very skilled work.

Jul 09, 2012 | Sony Bravia KDL-46Z4100 46 in. LCD HDTV

1 Answer

It keeps flashing between flashing lights regards


Hi.

The TV stays in standby because protection circuit kicked in.

Protection kicks in when an internal fault had been detected.

In your case the SCART cable may have caused a short.

When on protection the TV will stay in standby, will not respond to buttons or remote, and will not start up.
All higher voltages from PSU get shut down by controller board, and only the +5V remains on.

To attempt resetting the TV, disconnect all video cables, disconnect the power cord, wait about one hour and plug it back.

If TV does not restart, then there may be an internal fault.

In that case leave TV unplugged for longer, just in case.

If still no luck, then call Sony to discuss a repair. The number is listed on your owner manual.

If instead TV will restart, do not use the faulty video cable again, this can damage your TV.

Regards

Nov 06, 2009 | Sony Televison & Video

1 Answer

Standby light stays on


When attempting to turn on the set, the standby light should blink for a a while then stop once the picture comes on. If a problem is detected internally, the standby light should blink in a repeated pattern. Please count the number of blinks that are repeating and we should be able to help.

Thanks,
Dan

Aug 01, 2009 | Sony FD Trinitron WEGA KV-32FS120 32" TV

1 Answer

Tv won't stay on


MY SAMSUNG 27# MODEL TXT27820 ONLY NINE MONTHS OLD SHUTS OFF BY ITSELF AND WILL NOT START AGAIN

May 10, 2008 | Samsung TXJ2754 27" TV

1 Answer

TV cut out and stay on standby


hold the power switch in from off for 10 seconds, worked for me.

Jan 06, 2007 | Sony FD Trinitron KV-28FQ75 28" TV

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Televison & Video Experts

The Knight
The Knight

Level 3 Expert

74118 Answers

Henry  Thomas
Henry Thomas

Level 3 Expert

1074 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1667 Answers

Are you a Samsung Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...