Question about Motorola Mobility H700 Wireless Headset

1 Answer

Headset will not turn on

When I plug in my headset, instead of a solid red light, it blinks between red and green. Then, when I unplug it and attempt to turn it on, nothing happens. What's going on?

Posted by on

  • l_tillery86 Jan 27, 2009

    It actually charged for a good 48 hours..... :o(

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 25 Answers

Hello to you, ahh yes the wonderful world of moto, it sounds to me like your not letting it charge long enough, when you start the charge it will go red, than after a bit it will go yellow and when fully charged it will go to a real dark green.( some times up to 3 hours, no!! im not kidding,) it amazes me how long it takes. step 2. when you want to put it in discover mode press the call button in till it turns solid purple than pull the mike down real quick and it should stay purple at this point you have 30 seconds to pair that puppy. good luck and you will get used to it. hope you only have one. i have seven.

Posted on Jan 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My nokia bh503 headset not charging


Leave it plugged in for 4 hours. Yello should turn red then green when fully charged

Oct 20, 2014 | Nokia Bh-503 Bh503 Bluetooth Stereo...

1 Answer

Red blinking light


Hi, Ephraim. The flashing red light indicates that the device is showing "low battery". It could be that the LG phone charger fits the charging port on your bluetooth headset but it is not compatible with your device. In order for you to know that it is charging, the device should show a steady red light(means charging).
Please take a look at the table reference below.
----------------------------------------------------------------------
•With the Charger Plugged In
______________________________________________________________________
•Headset Indicator Headset Status
Red-----------------------------------------------Charging (battery level less than 50% charge)
Yellow-------------------------------------------Charging (battery level more than 50% charge)
Green--------------------------------------------Charging complete
----------------------------------------------------------------------
======================================================================
======================================================================
======================================================================
----------------------------------------------------------------------
With No Charger Plugged In
__________________________
Headset Indicator Headset Status
______________________________________________________________________
Off ---------------------------------------------Power off
Three blue flashes------------------------Powering on/off
Steady blue --------------------------------Pairing/connect mode
Rapid blue/purple flashes -------------Connection successful
Quick blue flash --------------------------Incoming/outgoing call
Slow blue pulse --------------------------Connected (on a call)
Slow blue flash ---------------------------Standby (not on a call)
Slow red flash ----------------------------Idle (not connected to phone)
Slow purple pulse -----------------------Connected call muted
Steady red ---------------------------------Attempting to connect
Quick red flash ----------------------------Low battery

Note: After 20 minutes on a call or of inactivity, the light stops flashing to conserve power, but the headset remains on
----------------------------------------------------------------------

Hope that'll help you in some way.
**Please rate my post and/or leave a comment** ...Thanks...

Sep 25, 2013 | Motorola Mobility H560 Bluetooth Headset

1 Answer

I get blue/ red light instead of red/blue wen m pairing wid my iphone


Try resetting the headset: When plugging in the AC charger, hold the power/pair button down. The headphones will show a solid red or blue light when they have been successfully reset.

Good luck from Headsets Direct - 800-914-7996.

Aug 17, 2011 | Plantronics Backbeat 903 Bluetooth...

1 Answer

I'm trying to recharge my headset but the green light remains on (I clicked on the botton on the headset piece but it won't turn off). When I try to turn it off, it beeps at me


try doing a system reset press the call control button and the volume mute button at the same time for 5 seconds. when the talk indicator light blinks release both buttons. press the call control button again and the talk indicator light will blink again briefly headset is back to normal then unplug the charger from the charging jack for 5 seconds and plug back in headset is reset. if that doesnt work then replace the battery in headset.

May 05, 2011 | Plantronics CS55 Wireless Headset

2 Answers

Cs55 connects but has no sound on headset


The compatibility setting, in almost 100% of the cases, should be set to "1".  You can find it on the side of the base, it's a little turn wheel that will turn if you stick your thumbnail in it and twist.  I have seen one instance on the Cisco IP phones that requires the compatibility setting to be on 5, so try that as well.
If you have a lifter installed, make sure that the short telephone cable that comes out of the back of the headset's base unit is plugged into the handset port of the telephone (where the handset coily cord is normally plugged into).  You would then plug the handset coily cord into the front of the headset base unit.  Make sure you have that configuration, and try again.
Finally you can try a re-set.  To do this you should lift the headset off of the charging base, make sure the green light on the top of the base is off (the headset is off), and then do the following: 1. Hold down the mute button and the call answer button at the same time. (The mute button is the black little wheel on the top of the headset itself.  If you use the tip of your finger to push that straight in, it will mute the headset) 2.  Keep holding both buttons down until the green light below your thumb on the headset flashes for 2 consecutive series. 3.  Let go.  Wait about 20 seconds then try answering.
If this doesn't work, try a re-subscription: 1. Place the headset back on the charging base. 2. The two microphone volume adjust buttons on the back of the BASE unit should be pressed together.  This will start the red light and the yellow light blinking on the front of the base unit. 3. Hold the mute button down while the headset is still on the charging base.  Hold it down until the red light stops blinking. 4. Disconnect the power to the base so that the red light and yellow light turns off. 5. Plug the power back in after about 5 seconds of it being disconnected and make sure the red light on the front of the charging base is now solid and the yellow light is flashing. 6.  Pick up the headset and try again.

May 07, 2009 | Plantronics CS55 Wireless Headset

1 Answer

PL-CS55 headset lifts receiver but only get buzzing sound in


Try a system reset:
1. Lift the headset off of the charging cradle (the base).  Make sure the headset is turned off.  The green light on the base won't be on if the headset is turned off. 2. Hold down the call answer button on the headset at the same time as mute button.  The mute button is found on the little black wheel on the top of the headset.  Use the tip of your finger to push it straight in. 3. Hold both buttons until you see a green light on the headset flash.  It will be right below your thumb.  Hold both buttons until the green light flashes for a series of 2 flashes.  Then let go of both buttons. 4. Put the headset back on the charging cradle and wait 30 seconds.  Lift it back off and try again. 5. If this doesn't work repeat the process once more or try a resubscription.
Resubscription procedure:
1. Put the headset back onto the charging cradle.  Make sure the red light on the base is on and the yellow light is flashing. 2. On the back of the base there are two buttons for the microphone adjustment that can be pressed down.  Press both of those down until the red light and yellow light on the front of the base start flashing. 3. While the headset is still on the charging cradle press and hold the mute button until the red light on the base goes solid, and the yellow light stays flashing. 4. Unplug the power to the base and then plug it back in. 5. Wait 20 seconds and try.

Apr 22, 2009 | Plantronics PL-CS55 Wireless Headset

5 Answers

Green light stays on....headset not turning on


I have had no trouble with mine (3+ months of good use) until today. Same problem you had - green light won't go out, unit won't turn on. Jonsumer's solution got me to thinking, and this worked for me:

1. plug the charger into the wall.
2. plug the headset into the charger.
3. unplug the headset from the wall.

Plugging & unplugging the headset to charger multiple times had NO effect. It was only when I plugged it into the charger and unplugged the charger from the wall that the green light turned off and the headset began to work normally.

Jan 06, 2009 | Motorola Mobility MOTOROKR S9 Wireless...

1 Answer

Headset CS50


It sounds like you need to re-register the earpiece to the base. To do this, use the following steps:
1. Return the headset to the
Headset Docking Cradle

2. Press and hold both the
Speak Volume Adjust Buttons (+/-)
on the back of base unit for a
minimum of 5 seconds. The
Red Power Indicator will then
flash

3. Press and hold the Headset
Mute Switch (black button on top
of earpiece) for a minimum
of 5 seconds. The On-line
indicator (green light on boom)
will then illuminate.

4. Subscription completion is
indicated when the Power
Indicator is fully illuminated
and the On-line Indicator is
extinguished.

5. If subscription fails within 2
minutes the headset will return
to the un-subscribed state.

Aug 19, 2008 | Plantronics CS50 Wireless Headset

1 Answer

The headset keeps blinking a red light


I had this very same issue which was remedied when I unplugged the headset recharging dock for approximately 5 seconds then plugged it back in. After about 10 seconds everything re-synced and was fine after that. -No more blinking.

Sep 02, 2007 | GN Netcom GN 9120 Professional Headset

Not finding what you are looking for?
Motorola Mobility H700 Wireless Headset Logo

338 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorola Mobility Headsets Experts

Coss

Level 3 Expert

1043 Answers

Brad Brown

Level 3 Expert

13530 Answers

Danny Kuhlmann

Level 3 Expert

1442 Answers

Are you a Motorola Mobility Headset Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...