Question about Dryers

1 Answer

Kenmore 900 series dryer starts n stops - Dryers

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 169 Answers

Will it start right back up immediately or does it take some time before it can be restarted?

Posted on Jan 22, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Jimster
  • 240 Answers

SOURCE: kenmore 70 series model # 96573220

Sounds like the push to start switch has gone bad. Not to expensive to fix, and pretty easy to do as well. You can remove the rear of the console, remove the push to start switch (lift the tab, then turn to unlock) and replace. Be sure to mark your wires so they go back in the right order. Jim

Posted on Nov 18, 2007

  • 1073 Answers

SOURCE: Electric Dryer Starts, runs, warms, stops (Kenmore series 90)

you have a bad motor that needs to be replaced

Posted on May 06, 2008

  • 1 Answer

SOURCE: Kenmore 80 series dryer stoping after running for 10 to 15 minute

Start any cycle. Dryer runs for 10 to 15 minutes, then stops before cycle is complete. Start again, stops again in 10 to 15 minutes.

Posted on Jan 26, 2009

  • 2180 Answers

SOURCE: 9 yr old Kenmore 90 series dryer wont heat

is it gas ? next time open dryer door and send full model number if it heats for a while you have bad gas coils,when you change them out watch out for the coil with three prongs on it,there is a metal piece that sometime gets stuck in old coil when you remove it,if it happens just poke it out of old coil and slide it back on post where new coil will be installed

Posted on Nov 07, 2009

  • 1 Answer

SOURCE: I have a Kenmore 80 Series dryer. When I push the ...

Did you figure out what the problem was? I have the same problem with my Kenmore dryer.

Thanks

Posted on Jun 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kenmore 90 series dryer stop working. When I press the start button it sounds like its coming on but when I release it stops.



Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor going bad...

Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101
.............

Jan 01, 2011 | Kenmore Dryers

1 Answer

I have a Kenmore 80 Series dryer. When I push the start button it makes a noise but won't turn on or it turns on for a few seconds and then stops


Did you figure out what the problem was? I have the same problem with my Kenmore dryer.

Thanks

May 17, 2010 | Dryers

1 Answer

Kenmore 70 series dryer makes buzzing noise and stopped working


Hi,
A dryer can not start for many reasons...
This tip that I wrote will help you to figure out what is happening...

http://www.fixya.com/support/r4460438-dryer_repair_dryer_will_not_start

heatman101

Apr 05, 2010 | Kenmore 65942 Electric Dryer

1 Answer

Dryer stops but the timer continues on


Fixed! The "push to start" button was stuck. Must have been some dust. I pushed the knob a few times and that's all it took. Works fine now.

Dec 12, 2009 | Kenmore Dryers

1 Answer

Kenmore Dryer 90 Series will start but suddenly stop...


Hello , Sounds like your motor is over heating , it will run until the sensor shuts it down from getting to hot , it is most likley because the motor is covered in lint and needs cleaned. Hope that helps.

Dec 30, 2008 | Dryers

1 Answer

Kenmore 80 series dryer stoping after running for 10 to 15 minute


Start any cycle. Dryer runs for 10 to 15 minutes, then stops before cycle is complete. Start again, stops again in 10 to 15 minutes.

Nov 11, 2008 | Kenmore 63942 Dryer

1 Answer

Kenmore Dryer 90 Series will start but suddenly stop...


what starts and stops? the entire dryer or maybe the drum? Do you do anything to make it restart other than pushing the start button? This initially sounds like a temperature switch is opening and resetting after it cools. If you can describe the problem a little more in detail it would help.

Jan 27, 2008 | Kenmore 659 Electric Dryer

Not finding what you are looking for?
Dryers Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dryers Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

yadayada
yadayada

Level 3 Expert

76132 Answers

Brad Brown

Level 3 Expert

15639 Answers

Are you a Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...