Question about Beko Washing Machines

1 Answer

Doesn't want to go onto spin cycle just makes funny noises

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Beko Master
  • 17,129 Answers

Possible that there is slippage when the program comes to the spin mode. Please check the drive and see if the belt is slipping or the drive is jammed. If not check the motor drive.

Posted on Jan 21, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mark_37388
  • 100 Answers

SOURCE: Washer won't spin, but making funny noise and water drains

You have a broke motor coupling broken between the motor and transmission the part is not expencive but a little hard to explain how to put it in.

Posted on Mar 29, 2009

  • 1075 Answers

SOURCE: banging noise on spin cycle

most front loaders are balanced by a large: ready for this: cement block inside at the top of your machine and because spin is so fast it can sometimes hit inside your machine or it has brokin a peice off ,sorry but yours going to have to get the repair person out.adrian

Posted on Feb 15, 2009

localwonder
  • 6784 Answers

SOURCE: Spin cycle doesn,t work

Hi. this is a failed timer device. simply replacing the timer control module will eliminate these issues you are having.

Posted on May 27, 2009

  • 351 Answers

SOURCE: washer doesn't spin, just makes funny noise.

i would change the coupler between the motor and transmission.... whirlpoolpartssurplus.com

Posted on Jun 23, 2009

  • 414 Answers

SOURCE: Cycle stops and won't drain or spin. The 'end'

Have you checked the pump and filter are clear? bottom right flap on front panel to expose pump. Check the hoses are clear, particularly if it is connected under the sink, via a spigot connection. If the machine has good motor action, but not spinning effectively, it will more than likely be a drainage problem.

Posted on Jul 07, 2010

Testimonial: "Thank you. We got an expert in and it was a blockage in the pump. "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have the ATR6700FS1 front load washer. It goes fine until the spin cycle. It pauses & when I hit restart it makes a noise & doesn't spin. If I hit cancel & go to the spin cycle it


Hello Deanna Lytle - Often when a unit does not spin, it is because the unit cannot properly drain and dispose of the water and detergent solution. Does the unit make a humming noise? If so, the drainage hose/pump may be clogged and needs to be cleaned. If not, the washer may possibly be experiencing an issue with the door lock assembly, faulty pump, timer or control board not communicating correctly. Because it could be a number of any one of several underlying causes, I would recommend contacting a professional to properly diagnose and repair the unit.

Mar 29, 2013 | Frigidaire ATF6000ES Front Load Washer

1 Answer

Roper washing machine makes grinding noise on spin cycle but the tub doesn't turn


It sounds like you have a motor coupling that is broken. There are videos on YouTube to show you how to repair this. Search for "motor coupling repair on direct drive".

Nov 26, 2012 | Roper RAS8445KQ Top Load Washer

1 Answer

Beko WMP652W washing machine will start cycle but get stuck at end of wash, doesnt go onto rinse or spin any help please?


see the next steps and use the common sense: God bless you
When the cycle doesn't advance, it's probably the timer or a cold-water supply problem: It's the timer, if your washing machine fills with water and begins agitating, but the timer never advances--or if the washer is in a spin cycle and the timer won't advance. Then you need to replace the timer. It may be a cold-water supply problem, if the washing machine fills with water, agitates, drains, and spins, but then doesn't fill with rinse water. See There's no cold water.
8_2_2012_12_47_51_pm.gif

Aug 01, 2012 | Washing Machines

1 Answer

Kenmore 80 didn't drain during the spin cycle and leak underneath machine. Makes buzzing noise in the wash cycles.


The pump is likely damaged if it was leaking. Look for a ring of melted plastic on the face side of the pump. Check to make sure the hole is not rounded where the motor shaft enters the pump.
I'd replace the pump just to make sure the washer doesn't flood some time in the future even if the pump turn out to be ok now.

Vlad,
First Choice Appliance Service. Sacramento, CA

Jul 05, 2012 | Kenmore 3.2 cu. ft. Plus Top Load Washer

1 Answer

Model GLTF167A0S0 Serial XC22704657... The final spin frequently doesn't work. I tried another wash cycle and the "high speed" spin didn't work. I can manually start the cycle and it...


If the water is pumping out fine you may need new shocks. But if it is slow pump the shaft on the pump is loose and causing the noise and possibly the spin issue. If it is loud when it does go into a spin (sounds like a jet engine) you have bad bearings. Big bucks to fix.

Jun 03, 2011 | Frigidaire GLTF1670A Front Load Washer

1 Answer

Funny noise in spin cycle


u will change the drum belt. ask service people to change ur belt.

Mar 29, 2010 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

Will not spin and smells funny


Does the washer agitate while in wash cycle? Does it move at all? It may be that the motor that drives the spin and wash cycle is not working. If it smells funny, it usually means that you have bearings gone bad or a belt, if it is belt drive, broken. You can replace these parts. All the parts involved with spinning can be replaced. The parts are available from the maker. It may be a spin clutch, agitator gear, pulley, or a transfer case..

Please leave good ratings, email me if you have more questions

Aug 07, 2009 | Washing Machines

1 Answer

Washer doesn't spin, just makes funny noise.


i would change the coupler between the motor and transmission.... whirlpoolpartssurplus.com

Jun 23, 2009 | Whirlpool Washing Machines

1 Answer

The spin cylcle does not work . It makes a funny noise and does not spin


the drain is probably clogged you'd be surprised home much is in there

Apr 26, 2009 | Washing Machines

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Beko Washing Machines Experts

Tom Chichester

Level 3 Expert

34211 Answers

J D Wright

Level 2 Expert

393 Answers

 Russ Hill
Russ Hill

Level 3 Expert

3187 Answers

Are you a Beko Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...