An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: Nothing Works Shows F3 Error
The F3 error code is an oven temperature sensor fault. The
sensor is a small probe that sticks out of the back of the oven wall.
They do go bad and can be easily replaced. If I had your EXACT model
number (found along the inside of the oven door or lower drawer) you can replace it.hope this helps
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I have a Kenmore wall oven model 911.41059591 that beeps and flashes F2 or F3 and shuts off. ... The "F2" and "F3" fault codes is most likely indicating an open oven ... Next, the control panel will need to be taken off in order to measure the ...
Thanks for using FixYa. Error F3-E2 in your Whirlpool oven means oven too hot and to resolve
this issue you'll have to replace the oven temp. sensor (probe). Please
rate the solution if the issue is resolved or post a comment for further
Circuit board defective
Replace control board
1. The oven temp has risen above 665F and the door is not locked or 2. The temp has risen above 965F with the door locked
1. Check oven temp in mode that failure occurred. Replace EOC (Electronic Oven Control) if above limits 2. Check 8-pin connector. Check and replace oven temperature sensor if necessary
Oven temperature sensor is open (above 3000 ohms)
Check resistance of oven temperature sensor, check for open wiring between oven temperature sensor and control
Oven temperature sensor is shorted (below 500 ohms)
Check resistance of oven temperature sensor, check for shorted wiring between oven temperature sensor and control
Internal watchdog circuit has detected a failure
Defective EOC (Electronic Oven Control)
Check push buttons and dome switches on control
Logic interrupted (lock motor switch sequence)
Check door lock switches and wiring
Most likely problem is the oven temp. sensor. Should check around 1100 ohms at room temp. I would replace that first because it is the easiest and cheaper than an oven control.