Question about Smeg 24 in. DWF614SS Stainless Steel Free-standing Dishwasher

1 Answer

Smeg dishwasher wash cycle freezes ,

Our smeg dishwasher stops in mid wash cycle and i have to start it loads of times to get a fall wash as it just freezes. the far left 2 lights show too ? any one know what to do or what this means ?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 641 Answers
Re: smeg dishwasher wash cycle freezes , - Smeg 24 in. DWF614SS Stainless Steel Free-standing Dishwasher Dishwashers

Thanks for the information.

Posted on Jul 24, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

My top dishwasher drawer won't finish through the cycle. It runs fine on rinse only but not any of the wash cycles. It stops mid cycles, beeps like it has been paused, then tries to start again

Try to feel the temperature of water inside the dishwasher. If it is normal room temperature for the hot wash cycles then it is likely the heater is faulty.
It is not easy to replace unless you have good experience with repairing dishwashers.

Jan 17, 2013 | Fisher and Paykel 23 in. DD-603 Built-in...

1 Answer

Frigidaire FDB126RBS2

Be very careful, it sounds like an electrical failure, were the machine has cut out to protect you and itself. You need an expert there and quickly. Water and electric are a bad mix and more house fires are caused by washers than most other appliances.

Sep 23, 2012 | Dishwashers

1 Answer

My smeg dishwasher seems to be permanently in wash mode. The light on the menu of settings no longer flashes, but permanently is on, and when I run a load it never stops. I hear the two beeps as if the...

You have a timer relay issue ,probable need a new board for it ,a cheap fix would be to time it and see how long it take to run full cycle and put a regulaer outlet timer on it or a alarm off your stove or what ever,save a couple of bucks

Feb 16, 2011 | Smeg STX2 Dishwashers

1 Answer

My smeg dishwasher stopped during a cycle and warning lights E2 come on. suggesting that it has drawn too much water and to contact customer technical services, any idea what i need to do

E2 shows that the water level switch has been tripped or its faulty,interupt the programm and switch off the dishwasher then switch it on ,programm it again and start the washing cycle again,if the problem persist then test the water level switch for possible replacement

Jan 10, 2010 | Smeg Dishwashers

2 Answers

Smeg integrated dishwasher continually washing - won't move to drying cycle.

you should check the heating element. if the water is not hot enough, the timer will not advance. crack open the door mid-cycle. let the water stop flying around. then open it all the way up. if you don't get a big ball of steam, you have an indication that your heating element may not be working properly. this is not too hard to check the resistance with a multimeter and then replace, if necessary. good luck

Nov 02, 2009 | Smeg STA4645U 18" Fully Integrated...

2 Answers

Kenmore Dishwasher 587.15163401 knob stuck mid-cycle

See if it is stuck on a water heat cycle. if the heater circuit or the thermostat is not working properly it will continue to run looking for a rise in temperature. If these are in working order the timer it self could be sticking and not advancing.

Oct 23, 2009 | Kenmore 16602 / 16604 / 16609 Built-in...

1 Answer

Detergent dispenser on SMEG DWF 44SS1 doesn't open during cycle - any ideas?

this is Usually caused by a tablet sticking in the Detergent Dispenser. This will stop the Detergent Dispenser from opening at the correct time on the wash cycle.

Oct 18, 2009 | Smeg 24 in. DWI612 Built-in Dishwasher

1 Answer

SMEG DI 612CA. Dishwasher

Pisss!!! Comin from my asss!!

Mar 04, 2008 | Smeg Dishwashers

1 Answer

My Smeg dishwasher DWF 64 SSE won't go onto rinse or dry

Easy one first try this to see if it helps

Water pre-heating
Your dishwasher may pre-heat the water. If so, and if the water entering the dishwasher is cool, the heater may take up to half an hour to heat the water.

To avoid the wait, increase the incoming water temperature before turning on the dishwasher. Do that by running the kitchen sink faucet until the water runs hot. Or increase the temperature of the hot water to the entire house at the hot water heater.

Warning! To lessen the risk of scalding, don't set the hot water heater temperature higher than 120 degrees Fahrenheit.

Jan 29, 2008 | Smeg 24 in. DWF612WH Free-standing...

Not finding what you are looking for?
Smeg 24 in. DWF614SS Stainless Steel Free-standing Dishwasher Logo

1,185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Smeg Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Starnley Johnwells
Starnley Johnwells

Level 3 Expert

1029 Answers


Level 1 Expert

25 Answers

Are you a Smeg Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides