Question about Hotpoint Aquarius WMA42 Front Load Washer

1 Answer

How do i fit a drive belt on a hotpoint tumble drier

It is a hotpint aquarius drier

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 86 Answers

Hi, To fit the belt to your dryer you will need to remove the top of the appliance by removing the screws at the rear. Pull of the timer/control knob. Look inside the top of the t/dryer behind the control panel you will see little plastic stems which are attached to the facia panel. You need to knock these out to remove the facia. Once this is off then you can remove the the top 3 screws and the bottom 3 screws the front panel will now come off for you to place the belt on the drum and over the motor spindle. Becareful as the t/dryer will be very loose and will twist. it is easier to lay the appilance down on its back to stop everything falling about. Now you can put it back together in the reverse order....
Good luck.............

Posted on Jan 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hotpoint aquarius wd420 cannot stretch drive belt on there is no slide bar on motor which is fixed solid even after bolts are lossened its a washer drier no obvious way of attaching belt


There is no adjustment provided for tensioning belt as it is a stretch belt.
Best way to do it is to remove the rear panel, tilt the weaher forwards, get someone to hold it for you.
Put belt round motor pulley first, then slowiy feed it round the drum pulley, turning the drum pulley at the same time, it will be very tight, so watch your fingers, just keep going until belt is on, if it comes off, just start over
You can line it up properly in the motor pulley grooves once you have got the belt on.
Please rate my solution.
Thankyou.

Feb 25, 2010 | Hotpoint Ariston Aquarius WD420 Front Load...

1 Answer

Hotpoint Aquarius WMA32 - belt slipping off?


Probably it wasn't fitted properly. make sure the belt is tight when fitted, and at least 2 groves from either side at the motor shaft.

Jul 25, 2009 | Hotpoint Aquarius WMA42 Front Load Washer

3 Answers

Hotpoint aquarius tumble dryer, drum not going round but still


If you can hear the motor going, then the belt probably needs replacing, if no motor action, then prob is more serious.

Please rate my solution.
Thanks.

Jul 15, 2009 | Hotpoint Aquarius WMA42 Front Load Washer

1 Answer

Fitting a new drive belt to a hotpoint aquarius


Remove lower rear panel, tilt washer forward, getting someone to help, and fit belt round motor pulley, then fit belt round drum pulley, slowly turning the drum pulley round as you feed the belt on, it is very tight, and you might think the belt is to small, but this is normal, as the belt stretches, just persist, but be careful you do not trap your fingers. Good luck.
Please rate my solution.
TRhanks.

May 10, 2009 | Hotpoint Aquarius WF000 Front Load Washer

1 Answer

I am trying to fit a new drum belt on a hotpoint aquarius vtdoo reverse action


You need to remove the top cover, remove the right hand side panel,ease the drum forward and fit the new belt.
It is very difficult to fit the new belt without the proper tool avialable from Hotpoint.
It can be done without the tool, but be prepared to stuggle

Dec 04, 2008 | Hotpoint Aquarius WMA52 Front Load Washer

3 Answers

Hotpoint WD640P - Fitting a new belt


Put belt on motor pully first then turn big pully around!Like fitting bike chain.

Oct 11, 2008 | Hotpoint Aquarius WD63 Front Load...

1 Answer

Hotpoint aquarius 1300


it takes a fitting stap to fit but can be put back on by hand little tricky but can be done no probs

Mar 01, 2008 | Hotpoint Aquarius WD640 Front Load...

Not finding what you are looking for?
Hotpoint Aquarius WMA42 Front Load Washer Logo

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts

hungoverrr

Level 1 Expert

5 Answers

puggy666

Level 1 Expert

47 Answers

gbob59

Level 3 Expert

2963 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...