Production year and compatible tuner?

Try to send one email at " restoredclassic@aol.com " with the vehicle vin number and the serial radio (sometimes need to take off the radio to chjeck in backside).

Keep us updated.

did you try pressing the source button?

I found the manual on line , so thanks and I'll probably need you again in the future, Thanks Chouch 3

if u have cut the factory harness, then u may have cut the power on wire for the factory amp

be more specific with the problems you're having. following the instructions should be straight-forward. if you are using composite cables from the unit to your tv, be sure the composite/480i/480p switch is et to "composite". it'sa small black switch on the back of the unit. make your selection while the unit is powere off. Finally, the composit cables are usually plugged in to the "AV" inputs on the TV -- make sure you set your TV's input to "AV"

there is a button under the back of the face in one corner, just press around the back of the face with the car on until you feel the button press in and it should open.

If not you may have a bad ribbon cable that is not too expensive to replace.

is the cd store bought or home recorded-

are you using any separate amp?- if you are the blue wire on the back of the radio is probably turning off when you use a cd(the blue wire is for a power antenna, the blue with a white stripe is for an amp)

I once had the same problem and took it in to have it looked at! The guy simply pushed in the small black button to the left of the ATT button and it reset!

Hope that helps!

Check ribbon cable from main board to face for breaks in the lines. Replace ribbon cable if bad.