Water not coming out properly from one of the jets
I sat in my jakuzzi for 30 minutes and it went off for 7 seconds and came bach on its happened to me twice can some body help me. and the other problem one of the jets the water does not come out properly
An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: water not coming out properly from one of the jets
Hi there. FIrst of all be sure the water lever is above all of the jets for it to work properly. REgarding the jet where the water does not come out properly i am not sure what that means. BUT, the jet is adjustable so turn it and see if that fixes the problem. good luck.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Put white vinegar in the water and run it through your tub. Fill the tub to it's maximum running capacity, which is normally just above the jets, and pour a gallon of vinegar in the water with it. Let it run with the vinegar for about 20 minutes, then turn it off and let the vinegar sit in the jets for about 30 minutes. Then start up the jets again for about another 10 minutes and drain. Then run plan water through the jets for about 15 minutes, drain and that should do it. I would recommend doing this at least once every 2 months depending on your water type and how often you use the tub.
Are the particles like white chunks? If yes, I was told to get calcium and lime remover and add it to the water and let the tub run for 30 minutes. Once this is done, drain and then refill tub and run for another 30 minutes to get the lime and calcium remover out of the system. This should help.
I seen two tpyes one where the inter jet unscrew and the other where the outter ring unscrews not sure what kind you have . Went to the pool store and they had a cleaner you add to the water and then run the unit for about 20 minutes then drain . It seem to work pretty good and there was less hassel taking the jets apart
This is known as the purge cycle, it is very normal. It is to blow out any remaining water from the air jets. If it was to allow water to stand in the pipes, it would start to smell and grow algae, which would then clog the small air holes, nothing to be alarmed about.
Due to your tub setting for a long period of time, you have a simple air lock in the jet hoses. Find the pump - locate the jet farthest from the pump and using a funnel slowly pour water in that jet until water starts coming out of the other jets. Turn you tub on it should work fine. If this does not solve your problem you may have to loosen the top hose at the pump and allow the air to escape while being replaced by the water you are pouring in
This is normal for jets on hot tubs/whirlpools for the jets to shut off after 20 minutes. This is a safety feature to prevent overheating of the water. When jets are running, the hot tubs are constantly heating and can elevate to dangerously high temperatures excess of 110 degrees causing scalds that you would not even know are happening. Your body temperature acclimates to the climbing temps and you dont realize it is that hot. It also helps prevent you from falling asleep and not paying attention to the temps in the tubs. Sorry, but I think you are going to have to restart the jets after each cycle. It is a safety feature that can't be bypassed or circumvented. Good luck and happy tubbing
Your temperature control is way out of calibration or, it's wired wrong. Remove it and check it in a glass of water. Use an ohm meter across the heater wires. As you add hot wwater, the heater contacts should open.