Question about Kohler K-10270-4-BV Forte Two Handle Centerset Lavatory Faucet with Sculpte...
Cold water faucet needs to be replaced . I'm down to the the cartridge and I can't get to screw out? What's next? Help
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
you will have to replace the ball assembly with a repair kit
1 turn the water off under the sink (hot and cold)
remove the handle ( you may need an allen head wrench to remove a hex screw or you may have to take a channel lock pliar and unscrew achrome
nut over the ball mechanism
after the handle comes off there is usually some type of lock nut that you must remove to remove the ball mechanism
remove the ball (usually chrome or brass(ther are usually little springs and rubber washers under ball
take ball and washer to ACe or lowes and match the pieces (usually sold as a kit
follow directions and installl
turn water on and pat yo!ur self on the back !
Posted on Jan 05, 2009
ever since the pressure balancing regulations came out for shower valves, they have went from simple to very complicated devices. sounds as if some foreign material caused the valve to stop working. that valve is quit difficult to reassemble correctly because there is only one way it works and can be assemmbled many ways that do not work concerning alignment of the ports. if you dissassemble it and check that all the moving parts are functioning in the balancing cartridge you can then look closely at the alignment of the ports on the cartridge that the handle is connected to. understanding how the port align as the handle is turned should assist you in assembling it correctly......hope this helps.
Posted on Jan 23, 2009
You have to remove the "large" nut but you need to find a way to hold the faucet. Also, you will see a retaining washer that fits on the inside of that "large" nut. If you loosen this it will release some of the tention on it and hopefull make it easier to remove. Also, try using some lime remover on the unit will might alow the retaining nut to loosen. Good luck and if you can't get it off, contact Kohler, they have an 800 number and they can give you the info you will need depending on your model.
Posted on Mar 30, 2009
Try draining the system and apply air pressure (min 30psi) to each faucet. Open other hot water faucets to allow pressure to vent. Next try draining and cleaning the hot water tank.
Posted on Oct 24, 2009
My husband is a plumber. He says u need to pull it off with pliers. U need to just pull it off. It may take a couple tries, but it should come out.
Posted on Jan 04, 2010
Tips for a great answer:
Sep 18, 2014 | Kohler K-596-BL Simplice single-hole...
Feb 03, 2013 | Moen & One Handle Tub & Shower Faucet
Jun 15, 2011 | Kohler Plumbing
Jun 12, 2011 | Kohler Plumbing
Jun 03, 2011 | Kohler Model 10430: Fort® Single-control...
Dec 11, 2010 | Kohler K-10430-VS Fort½ Single Lever...
Nov 08, 2009 | Kohler K-12176-PB Fairfax Single Handle...
Nov 04, 2009 | Moen 7437 Chateau Single Hole Kitchen...
554 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: