Question about Heating & Cooling

Open Question

Manual for Charmglow fireplace insert 33EO5 - Heating & Cooling

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: Charmglow electric fireplace flame does not

You will have to connect a 12v dc power supply to the flame motor. The controller on the board has fried. I built a regulated 12 v dc power supply and tapped it into the bulb circuit so it will power the motor when the bulbs come on. You may have to find an electrician or techie to rig this up safely.Good luck!

Posted on Dec 28, 2009

  • 193 Answers

SOURCE: Charmglow fireplace, everything on, no heat

its either a sensor or the element most times sensor or limit.

Posted on Jan 25, 2010

  • 1 Answer

SOURCE: Charmglow Electric Fireplace ***NO HEAT** just lights up, HELP :(

Take the fan power switch apart and clean the 2 point contacts. Also clean the 4 male studs that the wires plug into. That should solve the problem.

Posted on Feb 13, 2010

  • 1 Answer

SOURCE: Need manual for Charmglow vent free freestanding fireplace

hold the knob down for at least 10 seconds when lighting the piolet, then let go and turn the know to 1 it should come on there is a thermostat that shuts off the gas when it reaches temp, just turn up the dial and you shoud get heat.
I have this model and if you set it on 1 or 2 it while cycle on and off as needed.'
Hope this was helpful

Posted on Mar 13, 2010

  • 4736 Answers

SOURCE: Charmglow electric fireplace - fake

If you are not getting any flame effects or the glowing ember bed, the bulbs (60 watt, small base chandelier) may be burner out.

To replace them, remove the plexiglass front and then the logs. The plastic glowing ember bed just lifts out, exposing the bulbs. Before replacing them, check to make sure they are not just loose in the holders.

Hope this helps you and thanks for choosing FixYa.

Posted on Sep 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace my charmglow electric fireplace with a gas insert


Check your local building codes for restrictions. You MUST have the proper exhaust for a gas unit. There may also be flooring and wall requirements that need to be changed.

Jan 18, 2013 | Heating & Cooling

1 Answer

I am needing a new blower for Charmglow propane ventless fireplace #cgn300tq


I can't find an owner's manual anywhere for this fireplace, but you are welcome to see if any of these universal fan kits look similar: Universal Fireplace Fan Kits.

Nov 30, 2012 | Heating & Cooling

1 Answer

Charmglow natural gas fireplace, CQN300TQ, need a manual


looking where to buy a thermocouple for natural gas fireplace cgn 300tq

Nov 01, 2011 | Napoleon 36" Zero Clearance Top/Rear Vent...

1 Answer

I need to get a manual for a Charmglow electric fireplace Model # CGN250TED-C 25,000 BTU Pure Comfort solutions and I cant find a website, i need to know where to change it from natural gas to propane. ...


I am almost totally confused. You started out saying you have a Charmglow Electric Fireplace. Then you said you want to change it from natural gas to propane.

Could you please be a little more specific in what you have? So I can help you. As Charmglow only makes Electric Fireplaces. No gas ones.

Thanks, I look forward to hearing from you.

Aug 10, 2011 | Williams 2509612 Ceramic Mid-Size Heater

1 Answer

Charmglow electric fireplace bad remote control


Here is the home site for Charmglow - you could try to call them and see what they say. I would hope they want to keep their customers:

Charmglow Products 3701 Charlotte St, Pittsburgh, PA 15201-3201 (412) 683-6434 .aBtnGetDir { display:inline-block; width:107px; height:22px; text-decoration:none; vertical-align:bottom; cursor:pointer; } .aBtnGetDirLeft { float:left; height:22px; width:92px; overflow:hidden; font-size:0.85em; background:transparent url('http://sp.ask.com/sh/i/a11/shared_sprite_06.png') no-repeat -99px -401px; color:white; font-weight:bold; text-align:right; vertical-align:middle; line-height:22px; } .aBtnGetDirRight { float:left; height:22px; width:15px; overflow:hidden; background:transparent url('http://sp.ask.com/sh/i/a11/shared_sprite_06.png') no-repeat -301px -401px; }

Dec 12, 2009 | Kitchen Appliances - Others

1 Answer

Ventless gas fireplace can't light


You have the wrong piece of equipment and do not list what I need.

Jan 21, 2009 | Home Decorators Collection Charmglow...

2 Answers

Replace light bulb in a Charmglow electric fireplace


you have to remove the doors and then the lower ember cover, he lighs are underneath.... i am looking on how o make he flame move, it froze and won look like real fire anymore

Oct 21, 2008 | Kitchen Appliances - Others

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Heating & Cooling Experts

paulcarew

Level 3 Expert

2458 Answers

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Donni Steen

Level 3 Expert

659 Answers

Are you a Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...