Question about Samsung LN-T5271F 52 in. LCD Television
I have a Samsung LN-T5271F LCD TV that is about four years old. It has a screen problem that I will try to explain. It has a severe flicker/jitter in the bottom left quadrant of the screen. It has four equal horizontal bars on the screen. The top bar does not flicker/jitter, but the further down the screen you go the worse it gets. It is also does not flicker/jitter on the far right side of the screen, but gets progressively worse towards the left of the screen. Any suggestions? Thanks.
The main power supply regulator section circuit fault. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Pull up older posts.
It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size.
Posted on May 27, 2017
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Most likely the TV has a power supply related problem. It's possible that it maybe a bad capacitor or transformer on the power supply board.
But, I can't say it's 100% the problem because I can't actually look at the tv over the internet. I can only make guesses with the symptoms.
You have a few choices:
1. You can try leaving the TV unplugged for 30 - 45 minutes so the TV can discharge and reset itself.
2. If by chance the TV is still under warranty by extended plan, go that route.
3. If you have some electronic experience, if you can find and purchase a Service Manual over the internet; It will help you diagnose the source of the problem and fix it by soldering in the new part. The Service Manual will give you red light blinking codes, circuit diagrams, test points, and part# lists.Usually, cost under $20. And most cases the new part cost less than $15.
4. Pay a TV shop to do the repairs. It maybe costly, but get an estimate of how much they will charge. That way you can decide if it worth repairing or replacing the whole TV.
I hope I shed some light on the subject for you.
Posted on Jul 15, 2009
Call Samung customer service, they are doing this repair for free. I had the same problem at 11 months, they replaced the power supply board under warranty. At 2 years I had the exact same problem again and this time they replaced 2 - 50 cent capacitors on the power supply board. It took the repair man less than an hour and he had the replacement capacitors on hand. The original board and the replacement board they gave me had capacitors that were faulty. Hopefully these new capacitors will last. I have to say that I was thinking (no more samsung products for me) but I got excellent customer service and they admit that they had a faulty product and they accepted responsibility.
Posted on Jul 21, 2010
All lasma an lcd ts have boards that control vertical and horizontal output to their respective areas. They are connected to the screen by ribbon cables. If one of these boards fails all together, has a failed chip, a bad connection, or a bad ground somewhere it will result in a black line in the area of that board. A bad ribbon cable connection on the bottom will result in a vertical black bar though the screen. Many times reseating the connection will fix it, if the ribbon cable has been nicked there could be a severed connection. They an sometimes be fixed, but it is a pain. An yes I have done it, but the bar is gone. The same will happen if the chip that outputs to that area opens. The connectors are the first place to look paying close attention to the cable, they are extremely delicate so great care must be taken if you decide to tinker with em, the usually have lift locks that release them, but it is very easy to wreck em.
Posted on Aug 15, 2010
Do these bands appear even when no input is connected to the tv? It will help us isolate whether its an LCD controller problem or a problem with the video processing circuits
Posted on Feb 20, 2011
Tips for a great answer:
Jun 27, 2014 | Samsung LN-T5271F 52 in. LCD Television
Feb 26, 2008 | Televison & Video
Aug 08, 2012 | Samsung LN-T5271F 52 in. LCD Television
Jan 24, 2011 | Samsung LN-T5271F 52 in. LCD Television
Apr 26, 2010 | Samsung LN-T5271F 52 in. LCD Television
Apr 14, 2010 | Samsung LN-T5271F 52 in. LCD Television
Dec 14, 2009 | Samsung LN-T5271F 52 in. LCD Television
Aug 24, 2009 | Samsung LN-T5271F 52 in. LCD Television
Nov 10, 2015 | Samsung LN-T5271F 52 in. LCD Television
Mar 26, 2012 | Samsung LN-T5271F 52 in. LCD Television
49 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: