Question about Televison & Video

1 Answer

If you listen close to the tv it gives a strange noise when the volume is high

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Filmmaker:

    Uploaded 5 video answers.

  • Expert
  • 88 Answers

Youre more than likely getting elecrical "noise" or interference from a radio or cell tower. Get a quality surge protector, i have one made by Monster and it knocks out the interference.

Posted on Jan 15, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Technician (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I get a strange digital noise while recording speech. While no speaking there is no noise


Perhaps speaking too close to the microphone, and/or volume input (if settable) is too high.

Aug 15, 2015 | GPS

1 Answer

My tv has no sound


increase the volume to max level .close yourself to TV speaker and listen.if could not hear anything,just turn it off and turn on if you could not hear at least pop sound from the speaker,you will have to replace new speaker.if you are able to hear Buzz noise or very low sound ,sound circuit has to be repaired.

Jun 15, 2011 | JVC Televison & Video

1 Answer

When I'm playing on my amp there is a strange noice coming out of my amp. At first I thought it was my guitar, but it is really my amp... does anyone know how to solve?


"A strange noise" does NOT give us much to go on...

Please note that relatively low volume digitizing noise often exists from teh digital effects processors... it should be well below the normal playing volume.

Aug 09, 2010 | Line 6 Spider Iii 15 Modeling Guitar...

1 Answer

High pitch whistle ina 650 V Star Classic. 19999, about 21k miles. Owned the bike since '01. It's been serviced regularly and the dealership says it's a standard noise. Aggrevating for an otherwise...


Hi, Royalflush84 I would love to help you with your engine or chassis noise but I just loaned my brand new pair of listening ears to your local dealer's chief technician so he could take your bike for a test ride and give you his professional opinion and estimate about your noise and repair cost. For more information about your issue and valuable "FREE" downloads that you need please click on the links below. Good luck and have nice a day.
Whinning Noise HELP
http://www.r6-forum.com/forums/57-garage-mechanical-help/154101-strange-high-pitched-noise-coming-motor-anyone-can-help.html
http://www.sloneservices.com/SilverBack/Other-Stuff/V-StarShopManual99-07.pdf
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2003/LIT-11626-16-05_22.pdf

Aug 05, 2010 | 1999 Yamaha V Star Classic

1 Answer

On my Sony Surround Sound tuner, if I raise the volume up to a certain level (not that loud), I get a flashing sign ''protect'' and the sound to the speakers are cut.


Sony has protection in these receivers for two main reasons.

1 - Checking for DC voltages on the outputs to speakers. Not your particular problem.

2 - Excessive current being drawn from receiver on one or more of the speakers.

Number 2 should be your starting point in finding a solution. Put the volume level on Medium - 35 to 40 on the front panel. Now listen to all you speakers in turn. Any scratching noise will indicate a defective speaker. Remove this speaker from the receiver output and check again if the set goes into protection on high volume.

If you could not find any strange noises on the speakers, remove them one by one and test the set on high volume.

Never - attempt to disengage the protection on this amplifier. The only times we have found the amplifier to be defective with this protection error, it has done so no matter the volume level. Therefore I believe your problem to be a speaker or speakers.

Good luck!

Sep 13, 2009 | Sony Audio Players & Recorders

2 Answers

Volume making humming noise when on


there is a bad ground.
the hum you are hearing is ac getting into the audio.check all the rca plugs on the set are plugged in all the way.do not run them close to a power bar either.
sometimes a second unit with it's own volume is hooked up to the tv and then the tv volume is up too high because the other box is turned down.if there is a unit hooked up,turn it's volume up ,and the volume on the tv down,otherwise the tv will amplify the residual noise.cheers,ed

Jul 04, 2009 | Proscan 32LB30H LCD TV

1 Answer

I'm experencings a buzzing noise coming from the speaker when I turn on the tv....How can I get rid of this noise?


Give this a shot, it should fix the hum issue:

1. Turn tv on
2. Input mode should be tv
3. Turn volume to zero
4. With remote enter 9 8 7 6
5. A menu will appear on left side
6. Arrow down to backlight and with right arrow key move number from 81 to 83, press menu button twice,
7. Turn up volume and listen if hum is gone.

Let me know if this works.

Feb 19, 2009 | Proscan 32LB30QD 32 in. LCD TV

2 Answers

Annoying sound


i forgot to mention,when i take the belt away from the mechanism that turns the deck,the scratch noise stops..

Jan 15, 2008 | Panasonic Technics SL-BD22D Turntable

3 Answers

High Pitched Noise


most high pitch noise comes from the anode conection on the picture tube thats connected to the flyback anode cap thats mean there is a high voltage leak,to stop the noise you can discharge the high voltage take off the cap and clean with alcohol.if the noise continue.you will have to put some red or clear silicone both the cap and tube stick together leave to dry for about 2 to 4 hrs.this will eliminate the leaking.good luck.

Jun 11, 2007 | Toshiba 27A41 27" TV

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

74634 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6694 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...