Question about iLO LCT32HA36 Television

3 Answers

Ilo LCT32HA36 won't show a picture but does have power

I have an ilo LCT32HA36 that is about two years old. The other night I was walking by the television and went to shut it off using the power button on the tv. When I pushed it, I got one of the worst shocks of my life! Now, when I push the power button the green light comes on, but there is no picture. Every few seconds the green light on the front flashes to red and then goes back to green. The remote will not power it on or off, nor change channels. If I continually hit the on/off button on the tv, I might get it to come on once every 20 times. However, the picture might stay for a two seconds and then it goes off. If you leave the power on (green light is on) and just leave it, the picture might flash for about one second and then go off. Some research I have done says it a fuse, some say it is the video board. If it is the video board, which one do I need, where do I get it and how do I put it in?

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

Hi, I had a computer monitor that acted similar one time and what I found were that there were some bad capacitors in the power supply board inside. They were identified by the swelled up rounded ends and the heat discoloration of them. They look like little aluminum cans with a vinyl sleeve shrunk around them with the component values written on them. A normal one is flat on the end with no signs of any leakage around them of a brownish blackish substance similar to wax or tar. They are relatively inexpensive at an electronics supply store($1-2 each) so I replaced them all. This will require some soldering and electronic repair knowledge though. The power supply could not stabilize so it just kept shutting down the picture that only displayed for a brief instant.
Good Luck!

Posted on Jan 24, 2009

  • Kenneth Walker May 04, 2011

    The shock did not come from the TV, but was static electricity from you going into the TV.
    The control circut has that pulse of electricty running around inside it.
    If you unplug the TV and leave it for about an hour and plug it back in it MAY operate...
    If it still does the same thing, the control circuit (controls everything that the remote contnrol does) is at fault.

×

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My ilo dose the same thing, I unplug it and then plug it back in right away and then it work's fine. The problem is I have to do it everyday.I want to know why that is and how can it be fixed? Anyone than can help please e- mail me - card_sam@hotmail.com- Thank's.

Posted on Mar 26, 2012

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Green screen

Posted on Jan 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power won't come on


No power signal lights appear?If no power lights try to check the fuse inside your TV.remove the back cover to see the fuse location.It is located besides the power supply.check it if busted,then replace the same value of fuse.Unplug first before removing the cover to avoid electric shock.thanks!!

Jul 07, 2011 | iLO LCT32HA36 Television

1 Answer

Horizontal is flickering


flickering as the picture becomes smaller and bigger or are there lines showing up? Please describe it better if you can so I know exactly what you are seeing. Any color changes?

Jun 28, 2008 | iLO LCT32HA36 Television

1 Answer

LCT32HA36 Won"t come on ,No lights, Nothing happens


Try website 1-800-Remotes Factory original.Buy an exact remote.

Mar 02, 2010 | iLO LCT32HA36 Television

1 Answer

The sound comes on but it was taking the picture


There are two places to look for the problems, the backlight inverter board and the power supply. Look at the power supply first since it is easier to get to, look for burnt parts, bad capacitors, etc.
http://en.wikipedia.org/wiki/Capacitor_plague
Please post back what you find.

Dec 16, 2009 | iLO LCT32HA36 Television

1 Answer

ILO 2600 SILO LCD COLOR TV


sounds like the power supply

Oct 12, 2008 | iLO LCT32HA36 Television

1 Answer

ILo tv


It looks like the power supply failed on your TV. If the LED is solid red or green, it could be some leaky or dry capacitors but if the LED is blinking, the failure is more complicated to repair.
I service these power supplies. If you need more info you can send me an email to jah2mil@hotmail.com

Jun 04, 2008 | iLO LCT32HA36 Television

1 Answer

Ilo 27" lcd tv


If your LCD has a defective power supply module will cause the following symptoms:
No Display and no Sound, Then Power indicate light changes from Green to Red.

Apr 29, 2008 | iLO LCT32HA36 Television

1 Answer

Ilo lct 42ha36


HI
YOU NEED VIDEO BOARD.
GEORGE

Apr 27, 2008 | iLO LCT32HA36 Television

1 Answer

32" lcd ilo tv


Call 800-726-4405 - but you will have to ship the television to California at your expense to have it repaired or replaced.

Nov 16, 2007 | iLO LCT32HA36 Television

Not finding what you are looking for?
iLO LCT32HA36 Television Logo

357 people viewed this question

Ask a Question

Usually answered in minutes!

Top iLO Flat Panel Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

The Knight
The Knight

Level 3 Expert

68368 Answers

Jim Goldsmith
Jim Goldsmith

Level 3 Expert

1869 Answers

Are you an iLO Flat Panel Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...