Question about Whirlpool GS460 Gas Kitchen Range

1 Answer

Igniter keeps sparking when it is shut off

Right rear burner

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,214 Answers

Remove each of the burner caps from the cook top and wash in warm soapy water, using a plastic scrub brush to clean any grease or film from all surfaces.

So the same with the burner seat and ignitor knob on the cooktop.

The ignitor keeps striking because it cannot sense there is a flame.

Posted on Jan 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why would the left burner activate the right igniter?


Sometimes a lot of the holes in the burner get plugged. I use a toothpick to clean them out.
Hope this helps.

Mar 20, 2015 | Kitchen Ranges

1 Answer

Left front burner not igniting...no spark but has gas,


automatic re ignition control (spark module), that's a common issue on all viking stove.
appliancesrepairla.com

May 12, 2010 | Viking VGIC485-6G Gas Kitchen Range

1 Answer

THE RIGHT REAR ELECTRONIC IGNITER DOESNT WORK


All of the igniters are connected together. When power is applied they all get activated and all burners spark. If one aint working either the ire to it is off, or the igniter have grease on it and therefore cannot get a good ground, or the hole beside the igniter is clogged and thus the gas won't ignite. This first video shows how they work and the second one is very important because it shows how to keep from damaging the stove while attempting repairs


May 08, 2010 | Maytag MGR4452BDW / MGR4452BDQ /...

1 Answer

JGC8536


If the front left also does not light normally, my best guess would be that the wires for the front left and right rear are crossed and the insulation may have fried. Besides that possibility, I have no clue.

Feb 14, 2010 | Jenn-Air JGR8850 Gas Kitchen Range

1 Answer

I have a Kitchenaid superba gas range slide in, model #KGST307HBS9. The nob of one burner, only, the left rear, will initiate the electronic spark that will light burners. When that nob is turned to...


Pull out the bottom drawer and you will find the spark module. I strongly suspect it is weak. Here is a video that shows operation:
This one shows the module on the backside but I looke dup yours and it is below in the backside of the bottom drawer. Ok here is what i think The igniters could be dirty and I have a video showing how to check that plus another video to show how to remove those pesky switches on the top burners and spark module operation.

TOP BURNER SPARK IGNITION

SEALED BURNER SCREWUP

Jan 02, 2010 | Kitchen Ranges

1 Answer

REAR RIGHT AND LEFT FRONTBURNER WON'T IGNITE


The most common problem for gas surface burners is that they get gas but don't light. This is generally caused by dirt or grease splatters on the burner itself. Residential-grade range/stove burners are round and have small holes around their perimeter to allow gas to flow out and create a round flame. The gas coming from these holes is often ignited by a small vertical row of holes on the side of the burner. If these vertical holes are clogged or obstructed, the gas can't ignite.

The solution is to clean the burners thoroughly. Use a toothpick to clear the small vertical holes, then allow the burner to dry completely and try lighting it again. If it doesn't light immediately, repeat the procedure

May 12, 2009 | Magic Chef CGR3742 Gas Kitchen Range

1 Answer

GE Gas Kitchen sealed burner


I unplugged the wires from each end and re-attached the wires. Stove working great, no more clicking.

Dec 29, 2008 | GE Kitchen Ranges

1 Answer

Burner will not ignite.


facing the spark ignition, the burner has small holes that need to be clean, those holes are going down on the side of the burners, take a look a the ones that are working so that you can see the small flames going down facing the electronic pilot call the spark ignitiong, you can take a safety pin or a paper clip and clean them. many times the ignition is between the front and rear burners, it's where the spark ignite the burners.

Dec 13, 2008 | GE Profile Spectra JGBP90 Gas Kitchen...

1 Answer

Ignitors keep firing by themselves after my aunt cleaned them 24 hours ago After she did the major cleaning of the stove I used the oven and it worked fine. I lit a burner (Probably front?) and the left...


Apparently there was a water spill around the burner control knob and in the burner itself; We ran the burner to create heat and then turned it off and let the water dry out and evaporate from the burner and igniter area.

May 26, 2008 | Kitchen Ranges

1 Answer

Stove burner igniter does not work.


Your problem is not the igniter itself, but the burner switch that controls the igniter. All the igniters get their power from one spark module that is mounted somewhere in back of the oven. That's why you are able to get all the igniters to spark with only one burner control turned on. This is normal. That is also why you are able to light the burner in question buy turning on another burner. The spark is being provided by a switch that is working. To answer your question: the igniter is removable, but I don't think it's necessary. Cleaning them generally doesn't make them work better. I would check the wiring from the spark module to the burner switch and/or replace the switch. I hope this helps.

Jul 18, 2007 | GE Profile JGSP48 Gas Kitchen Range

Not finding what you are looking for?
Whirlpool GS460 Gas Kitchen Range Logo

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Kitchen Ranges Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Cindy Wells

Level 3 Expert

4753 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3051 Answers

Are you a Whirlpool Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...