Question about Sony FD Trinitron WEGA KV-36FS120 36" TV

1 Answer

Picture wont come on screen

When i turn on the tv the green light comes on and the sound but no picture, then a red light starts flashing where the green light was.

Posted by on

  • ayrehead17 May 11, 2010

    How is the TV hooked up? Do you have cable?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

This problem is in the power supply.the red lights indicate as the standby mode.

Posted on Feb 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tv will not turn on green light comes on then flashing red light it wont turn on


Parents Sony flat screen did the Same thing. I pulled the plug on the back of the TV for a minute plugged back in wha la! Problem solved

Nov 19, 2013 | Philips Magnavox 27MS343S 27" TV

1 Answer

Samsung model hlt4675sx\xaa projection tv wont work. the stand by/temp light flashes red and the lamp light flashes green? it makes the sound that it makes when it turns on but no picture. we looked at the...


It could be the temp sensor going bad. This sensor sits on top of the metal housing which the bulb assembly slides into. The bulb assembly will have a hole on top and this is where the sensor is above. There is a small blue and white wire that plugs into it. If you pull the wire out and put a paper clip or wire in the coupling you will basically bypass the sensor connecting the blue and white wire. If your tv turns on then that is your problem. Its cheap too. Here were my symptoms..1] Turn tv on 2] Bulb would light up..(which eliminates the ballast) regular picture would show up (which eliminates the bulb and color wheel) 3] 30 seconds later tv would shut down with 3 flashing lights. After bypass the tv turned on as always and hasnt shut down yet. Always un plug tv first. Get the replacement part to avoid overheating and possible fire

Jul 31, 2011 | Samsung DLP HL-P5663W 56" TV

1 Answer

I have Sony Wega and the picture just cut out and went to black. The sound wont come on and the TV wont even turn on. The light at the bottom of the TV flashes lamp light. We took the lamp light out and...


if u take out the lamp the green light will flash ,its not detecting a lamp at all.a bad lamp is being detected before you took it out.u will have to replace the lamp before u get a picture again

Sep 30, 2010 | Sony FD Trinitron WEGA KV-36FS120 36" TV

1 Answer

Turn on tv no picture no sound standby light starts green changes to flashing red


the number of red light flashes indicate where the fault lies...sony error codes are easy enough to find if you google the model with the number of flashes.hope this helps somewhat as you dont say how many blinks!!
regards,steve.
ps.line output transformer failure rates are quite high on these sets,usually resulting in two red blinks-pause-two red blinks-pause etc...

Sep 28, 2010 | Sony FD Trinitron WEGA KV-28CS70 28" TV

2 Answers

The power comes on and then turns off and the front green power light blinks.


There is a small IC in the power supply section,
not the IC regulator that's the problem.

Jan 06, 2010 | Philips 32PT6441/37 32" TV

2 Answers

Red ir light floashing and tv wont come on Onn lcd tv


red light flashing on bottom of tv and no picture

Nov 27, 2009 | Standard (CRT) Televisions

1 Answer

Philips tv powered off and wont turn back on


There is a smt located at 7404 [C-6 Bottom] A common problem, does the tv make a sound like it wants to come on? Location 3239 should be small resistor, 3414 another resistor and a driver transformer at 5402 if it looks burned. See MCM electronics website and see if there is a kit to repair this. Or ask for part #s as per location of problem area mentioned. What you will be doing is changing the timing so all the components will come on at the same time. If this is done correctly you will notice the top of tv screen will flash red, green and blue lines. This will be the new norm each time you turn it on. But it will be OK. This is what the flashing green light is telling you. signed the Green Lantern7!!!!!!!

Sep 03, 2009 | Philips 30PW8420 TV

1 Answer

TV SREEN GOES BLANK, BUT AUDIO CONTINUES NORMAL,


Try unplugging for 36 hours. I had the same problem but with no sound and picture

Mar 03, 2009 | Sony KP-53HS10 TV

2 Answers

WHY WONT IT COME ON?!?!?!?


If you would like us to help you, you must tell us what brand and model TV you have.

Aug 28, 2007 | Standard (CRT) Televisions

Not finding what you are looking for?
Sony FD Trinitron WEGA KV-36FS120 36" TV Logo

Related Topics:

328 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

68202 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

Are you a Sony Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...