Question about Projection Televisions
Hello there, I would unplug the unit and allow it to be off for over 24 hours and that should cause the memory to be gone, including the Vchip code where the TV set goes back to the manufacture's settings.
Its always best to write down codes for future refer.
Posted on Jan 23, 2009
Tips for a great answer:
Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes
pre-set with a lock code of "0000". You may change the code to any four-digit number you
wish. To change the lock code, follow the steps below.
Press the MENU button
Press [UP/Down] button to SET LOCK CODE.
Press [=> / <=] buttons to operate [lock icon appears]
Press ZERO to acess the lock code. The first digit will be highligted.
Press [ => / <=] button to select the number.
Press [Up/Down] button to move the next digit and continue to follow these directions for all the four digits.
Press OK button to finish.
Press the menu button when finished
DO THIS AFTER UNPLUG THE TV FROM AC MAINS WALL SOCKET, AND LEAVE IT FOR ABOUT 30 MINUTES OR SO, REPLUG IT TO ac MAINS, AND DO ALL THE ABOVE SAID PROCEEDINGS. THIS PROCESS WILL ERASE ALL THE V-VHIP CODES, IF SET, AND WILL ALLOW YOU TO SET AN OTHER OF YOUR OWN. The default V-Chip code is . Ok.
Apr 24, 2011 | JVC Projection Televisions
After you set the lock, you must use your pass code
to view a locked program, view the locked TV, view
a locked channel, cancel the lock, or enter the Lock
If you forget your pass code, you can view the locked
TV without entering your pass code. When you are
prompted for your pass code, press the number 9 and
QV keys on the TV remote control at the same time. This
process temporarily unlocks the TV.
When entering the Lock menu, this process deletes
your old pass code and prompts you to enter a new
• You can either enter a new pass code to open the
Lock menu and make changes or press EXIT to close
• If any of the locks are turned on and you exit the
menus when prompted for a new code, the old
code and all lock settings are retained.
• If all locks are turned off and you exit the menus
when prompted for a new code, then the previous
code is erased.
Mar 17, 2011 | Mitsubishi WD-62525 62" Rear Projection...
Dec 12, 2009 | Projection Televisions
Jul 17, 2009 | Projection Televisions
Jan 23, 2009 | Mitsubishi WS-55809 55" Rear Projection...
Dec 07, 2008 | Hitachi 57F500 57" Rear Projection...
Mar 06, 2008 | Projection Televisions
Nov 06, 2006 | Mitsubishi VS-45607 45" Rear Projection...
Dec 08, 2016 | RCA Projection Televisions
42 people viewed this question
Usually answered in minutes!