Altec Lansing ADA885 - Capacitor information needed
I recently vaporized a cap on the Audio processing board ( the one with the Zoran chip). It's the one in position C46. I would like to replace it, so I can see if the board is fried, but I'm not sure what the rating was. Is there anyone out there with the sub opened that can check?
I can post pics of the spot formerly occupied by it, as well as any other pics needed by anyone else.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
the speakers plug/outlet is
usually at the back of the computer you will have to open up the computer
to check the lead attached to the rear of the input plug make sure the
connection is good or you might have to clean
the dust from your computer dust causes static which causes your computer to
overheat and all sorts of problems be sure to wear an anti
static earth strap before touching anything inside your computer try
cleaning your computer of dust using a fine air blower from a compressor making
VERY sure that there is no MOISTURE in the air line specifically around the CPU
central processing unit and your SOUND CARD dust causes static to build up in a
computer causing it to overheat any many other problems hope this helps
check u have the lastest sound driver.or u can try uninstalling it and run driver cleaner then try reinstalling driver.if u are using vista u may have to go to audio devices and set from there.also try air the input plug whole just incase dust has settle there. hope this helps. dt
tape or solder a piece of metal across where the fuze and holder would go. OR go to radio shack, pick up a small cartridge style fuze holder and an appropriate replacement fuze. (if you dont have the original fuze, dont bother with this method) Open the box or case to gain access to the circuit board. solder a new holder to the contacts.
Be aware that I have no clue what the fuze holder on that particular model looks like.
Same issue showed up for me today very randomly...
HD comes on and off for no reason and sound cuts in and out. This fix worked for me:
1.Disconnect the left speaker from the sub woofer. 2.Take the 4 screws out on the bottom of the left speaker. (They are under the rubber matting you can just poke holes through it) 3. Remove the bottom plastic assembly from the speaker 4. Cut the 4 wires to the headset chip. Careful not to cut any others to the speakers themselves! 5. Unscrew and remove headset plug chip 6. Reassemble and plug left speaker back into sub woofer.