Vista supported drivers for GE camera

Check this link for GE/Jasco - sorry no vista driver planned (check right near the bottom of the page)

They have a "workaround" solution you can download for the 98063(the single easycam) - probably doesn't work on the dual, but might be worth a try.

here is the link for the drivers for all other windows versions if you decide to revert your PC, also would expect any vista driver produced by an individual would find it's way here pretty quickly. I wouldn't expect that soon, there were not so many 98068s sold;

http://members.driverguide.com/driver/de...

Sorry if it isn't great news, check again over the next few months and you might get lucky, but I think probably not.

Hope this helps some :)

EasyCam Installation Instructions For Microsoft® Vista
1. If your computer is connected to the internet, you will have to disconnect
from internet temporarily until the installation is complete.
2. Insert the CD that came with your EasyCam
a. Do not install the driver
b. Close the ?Auto Run? window
3. Remove the sticker from the end of the USB plug on the camera and plug the
camera into an available USB plug.
4. ?Found New Hardware window will appear.
5. Select ?Locate and install drivers software (Recommended)?
6. A Permission Dialogue box may or may not appear, depending on the version and
security that is set up.
a. If the dialogue box appears, click ?Next?
b. If the dialogue box does not appear, perform step 7
7. Window?s dialogue box will appear, ?Insert the disc that came with your USB
Camera?, click ?Next?
8. Window?s dialogue box will appear, ?The software for this device has been
successful installed? click on ?Close?
9. A ?Power Frequency? dialogue box will appear, click ?NO?
10. Click on the start button
11. Click on ?Computer?
12. Open the ?Local Disc (C:)?
13. Open Program Files
14. Open VGA USB Camera
15. Double click on AMCAP
16. AMCAP will open into a screen displaying what the camera is focused on. If this
does not occur, follow the steps below.
a. Click on ?Capture?
b. Click on ?Start Capture?
c. If you still do not receive a picture, follow the steps below.
i. Click on ?Device?
ii. Make sure ?CIF USB Camera (2110A) is checked
iii. Check on ?Options?
iv. Make sure ?Preview? is checked
v. You should now be able to see what the camera is focused on.

Respected Sir/Madam,
I have Dell PC 32 bit with Vista.
And also I have GE 98068 EasyCam(TM) Twin webcam.
I need drivers to install the camera. So please tell me where it is I get? and please send me any link to search.

Thanking You
Feliks
fxmel@mcn.com