An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: cant control volume with dish satelite remote
With the desired equipment on, press and release the Mode button until the light flashes behind the correct mode.
Using the tip of a pen or the eraser on a pencil, press the address button.
Enter the code (see links to find your code below) on the remote's numbered keypad for the equipment.
Press the Address button. If the code entered is valid for the remote, the mode light flashes three times.
To verify the code works, try several functions for that equipment.
Some codes may provide partial functions or respond differently than
the button's titled function. Try the other codes listed for that
device until you find one that offers more complete functionality.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
At this moment TV has to be ON (turn tv on by front panel)
3. continue with remote control pushing power button again and again and again SLOWLY
4. when the tv turns off then press enter to save your code.
There is usually a remote module mounted on the inside of the front of the tv that senses the remote signal. This controls all functions of the tv. If you are not comfortable in troubleshooting this, I would recommend a repair center.
Sounds to me like you need a new control panel board which should run you about $150-$200 max! might be semi burnt out like mine was and that is what i had to pay not sure if this helps but hey ya never know :)