My stroller doesnt have a foot rester

Hi,

We'd recommend you contact Graco for assistance

Contact Us Graco

I believe you either pull out the knob on the sides of the foot rest or twist them

The foot rest is part of the frame and not available as a part. Plastic can be welded google plastic welders or bumper repair to find a local work shop.
If you find this helpful please rate it!

Hi,

You need to locate the lever standing out proud on the right hand side of the upright legs of the chassis, push this down with your foot, then push upwards the back folding section (referred to as a 'band-stand') with your foot, the stroller will then collapse by pushing this forward away from you.

Hope this helps.

if you put your foot under the metal ribs at back of pushchair,and lift up,then either right left side should have a lever you push down with foot,hope this works

Hi,

To fold the Triumph, stand behind the stroller (as you would if pushing it).
On the right hand leg (just above the back wheel) there is a small arm sticking out, push this downwards with your foot, then kick up the centre of the back support with your foot (directly behind where the child sits and looks like a band stand construction), then push the handles forward and away from you, the stroller will then collapse shut.

I hope this helps.

Hi,

Although I cannot locate the instructions in an electronic format, looking at the image I would suggest that it may be the following:

Down the right-hand back leg of the stroller, there is a horizontal peg sticking out, push this down with your foot, this will then allow the pram to be pushed forward (away from you) and then folded. You should have a locking device on this to keep it closed. If the locking device is on now (an it's already folded) don't force it as you will break it.

I would ALWAYS recommend that you contact the supplier for advise also.
If you go to a local baby shop and ask them to take a look this will help, although I seem to remember that this folds and opens very similar to the Maclaren Techno XT.

I hope this helps.

its the problem of nut and bolt.Please adjust the leg properly and tight the screws

if it's the silvercross pop,put the back poles in first then the leg rests the button bits go in the holes,then the cover goes round the front of the pole to attach the slide on bit then the popper then put the hood on.

hope that helps.

Are you talking about the seat fabric and putting it onto the frame?

Remove the handle bar and the metal pole from the seat frame legs to relaxe frame, put seat fabric ontop top of seat frame and fit. place one strap onto the pins at side with holes then turn seat frame onto side. use foot and weight to bring the other strap over the pins and slot into holes fasten buckle undernethe and the velco tabs.