Question about Evenflo Triumph 5 - Playwright Ash

1 Answer

Cannot recline how do i recline? plus where do i download a manual?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 944 Answers
Re: cannot recline

You can get a user manual on this link; check also this link, there is a safety recall on some Triumph seats; Hope this helps, there are many instruction videos etc on the site too :)

Posted on Jul 01, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

I installed the car seat in my car and doesn't recline, how can I recline this car seat? Also I press the botton and pull the recline handle, but doesn't look right either.

Try this site and input your model # and date of manufacture.
You should be able to print instructions. If not call them.

Dorel Juvenile Group
Consumer Relations Department
P.O. Box 2609
Columbus, IN 47202-2609

Phone : (800) 544-1108

Mar 08, 2011 | Safety 1st AllinOne Convertible Car Seat...

6 Answers

My maxi cosi tobi seat wont recline

Yes it seems to be a design fault. Has happened twice on our Tobi seat.

To fix, lay the seat on its back.

Locate the 3 Torx head screws middle front and rear left and right. You'll need a Torx screwdriver or head of the correct size.

Undo the screws, then pop the four catches at each corner with a flat-head screwdriver and remove the base.

Look at the recline mechanism, you'll see large bar at the rear (both sides) which is meant to be there. At the front, on one side or the other, you'll see a smaller bar which is part of the hinge for the recline handle. It's slipped sideways and into one of the recline mechanism slots.

Jiggle the recline handle and push the hinge bar back into the centre. It might help to use gravity - lay the seat on its side with the blocking bar uppermost. I can't see a way to prevent this slipping out again over time.

Snap the base back on and replace the Torx screws.

Jan 03, 2010 | Baby & Toddler Car Seats

1 Answer

Install graco snugride to a graco stroller

Fitting your Graco Snug Ride infant seat into a Graco stroller is usually easy to do -- the exact instructions just depend on which stroller you have. Typically, all you have to do is fold the stroller's canopy back, recline the seat (if it reclines), and snap the car seat in (backwards -- facing the rear of the stroller). You can hear it lock in place when it's in correctly. Your stroller's manual will have specific instructions, and if you don't have the manual you can find it online.

Which Graco stroller do you have?

Nov 24, 2009 | Graco Snugride

1 Answer

Maxi cosi xr

You can download the user manual via the link on this page, just below the features listing:
Have a look page 3, illustration 10

Hope this helps,
Erwin de Raad

Jun 03, 2009 | Maxi-Cosi Maxi Cosi Rodi XR 'Phantom'...

1 Answer

How to use recline function for britax kidfix seat?

A bit late to reply, but check out the video here;

Recline only works for ISO fit, basically put your hand into seat slot and grab the handle, push/pull to recline the seat

Feb 02, 2009 | Britax Monarch - Red Racer Booster Car...

2 Answers

Maxi cosi Priori, Adjustment of straps to the upper of the three

There is a door in the back of the seat (only accessible when the seat is fully reclined).  You have to open this door.  You can then pull the splitter plate out from behind the seat.  It is easiest to do this if you loosen the straps all of the way.  Remove the straps from the splitter plate, and rethread them through the desired slots and re-attach to splitter plate.  Close the door and you are done.

Jan 29, 2009 | Maxi-Cosi Priori

2 Answers

How do you make the britax monarch a backless booster?

While holding onto the base, push the backrest all the way backward. This will take some force. Once the backrest is flat, you can slide the axel off. Note that it only slides off one way - toward the open end.

Oct 06, 2008 | Britax Monarch - Red Racer Booster Car...

3 Answers

Can't put back together

contact cosco as they are the manufacture, this attached link will give you a site that with the model number and manufacture date you can download the manual which will tell you how to put it back together

Aug 10, 2008 | Eddie Bauer 22864MRC Booster Car Seat

1 Answer

How to recline 3 in 1

I suggest you recline it before you put it in the car.

Apr 28, 2008 | Eddie Bauer 3-In-1 with Latch

2 Answers

Britax Roundabout

its easier to do while its buckled in or someone is holding the base....

Apr 17, 2007 | Britax Roundabout

Not finding what you are looking for?
Evenflo Triumph 5 - Playwright Ash Logo

151 people viewed this question

Ask a Question

Usually answered in minutes!

Top Evenflo Baby & Toddler Car Seats Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21840 Answers


Level 3 Expert

3018 Answers

D. E. Hev

Level 3 Expert

1059 Answers

Are you an Evenflo Baby and Toddler Car Seat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides