Question about New Ray Geico Honda CR250R Motorcycle Model

Open Question

What is the best cleaner to clean motorcycle carborator

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to clean carborator of TVs xl super


You will need some carb cleaner in an aerosol, and access to an airline to blow out any debris. If you have never done this before, carbs have lots of small parts and you may need a knowledgeable pal to look over your shoulder the first time.
When you use a blow gun wear eye protection!!

Aug 01, 2014 | Motorcycles

1 Answer

How to clean the carborator om my 2007 vespa 200l


might be a problem with the electric choke sitting on the carburetor.
-or you should adjust the air/fuel ratio & idle speed settings on the carb (by a Vespa-shop) clean-carborator-om-2007-vespa-200l-btrmhpso54mmu3efswgwknhc-3-0.jpg clean-carborator-om-2007-vespa-200l-btrmhpso54mmu3efswgwknhc-3-2.jpg

May 17, 2014 | 2006 Vespa Granturismo 200 L

1 Answer

Why does my 99 honda shadow 600 choke out when i throttle?


most likely carbulator related , but i would try gas first , pick up some fuel cleaner preferably when bike is on e , pour in tank , and turn bike on , throttle it down with just the fuel treatment to really clean it out , if problem still persist check the choke on the carborator it may be to open causing a choke out as well

Apr 09, 2013 | 1999 Honda VT 600 C Shadow

1 Answer

GENERATOR WON'T START. IT HAS NOT BEEN STARTED IN ABOUT THREE YEARS.IT DID START AFTER I REPLACED SPARK PLUG,BUT ONLY FOR ABOUT 30 SECONDS..ALSO SPRAYED STARTING FUID IN CARBERATOR. NO GO.


FIND THE FUEL SHUT OFF VALVE.IF IT WAS CLOSED WHEN YOU HAD IT RUNNING,THE FIX IS AS SIMPLE AS DRAIN OLD FUEL,REPLACE WITH FRESH GASOLINE,OPEN THE VALVE TRY TO CRANK IT AGAIN.
IF IT WAS OPEN WHEN IT WAS RUNNING,SOUR GASOLINE AND VARNISH HAS LIKLEY GOT TO THE CARBORATOR.
REMOVE THE AIR FILTER,LOCATE THE BOLT IN THE CENTER,ON THE BOTTOM OF THE CARBORATOR BOWL AND REMOVE IT. CAREFULLY EASE THE BOWL STRAIT DOWN,AS NOT TO BEND THE TAB THAT CONTROLS THE FLOAT LEVEL,OR LOSE THE FUEL INLET JET. EXAMIN THE BOWL FOR CORROSION OR GUNK.
THIS IS AN INDICATION THE CARBORATOR MAY BE PLUGED WITH GUNK,WHICH COMES FROM GASOLINE SOURING AND TURNING TO VARNISH AS IT EVAPORATES OVER TIME.
ON THE CARBORATOR,WHERE THE BOWL WAS TAKEN OFF,IN THE CENTER ON THE BOTTOM NOTICE THE FUEL PICK UP TUBE,TAKE A PIPE CLEANER AND CLEAN IT BY PUSHING STRAIT UP AND DOWN A FEW TIMES,THEN FLUSH IT WITH CARB CLEANER.
REPEAT THIS UNTIL IT IS CLEAR.
LOOK CLOSELY AT THE SIDE OF THE PICK UP TUBE FOR A VERY SMALL HOLE,WITH A SMALL WIRE,CLEAR THE HOLE AND FLUSH WITH CARB CLEANER.
CAREFULLY REPLACE THE BOWL AS NOT TO BEND THE TAB ON THE FLOAT,MAKE SURE THE NEEDLE JET IS IN THE NEEDLE SEAT AS YOU PUSH THE BOWL INTO PLACE.
PUT THE BOWL BOLT BACK IN,CAREFUL NOT TO OVER TIGHTEN IT.
WITH FRESH GASOLINE IN THE TANK,AND THE FUEL VALVE OPEN,YOU ARE READY TO TRY CRANKING IT.
IT MAY TAKE A FEW TRYS.
IF YOU FEEL CLEANING THE FUEL SYSTEM IS TOO MUCH FOR YOU,PLEASE DO NOT ATTEMPT THIS.TAKE THE MACHINE TO A SMALL ENGINE MECHANIC.
YOU MAY CAUSE COSTLY DAMAGE TO DELICATE PARTS OR UNINTENTIONALLY CHANGE THE FLOAT LEVEL CAUSING FLOODING OR STARVING OF FUEL TO THE ENGINE.
BEST OF LUCK...

Nov 05, 2010 | Coleman Powermate Proforce 2500 Generator

1 Answer

Carborator only lets it run when choke is on


The slow circuit of your carburetors is dirty or plugged. Take the carbs apart and squirt carb cleaner through the slow jets and the carb bodies. Count the turns in on your air screws, pull them and squirt cleaner through those passage ways too. Be sure to carefully remove, clean and inspect the carb tops too.When everything is clean and in good shape the bike should run great.

Aug 17, 2010 | 1981 Yamaha XS 400 Special

1 Answer

I just fully cleaned the carborators and replaced


Were the carbs leaking before you took them apart?
try this use a rugger mallet of the hadle of a hammer and rap on the carb body to jar the carbs some times after rebuilding the carbs the float has not reacted to the fuel level. or you missed something in replacing the needle seat. If the carbs where gummed up from old fuel the little plunger on the float needle may be stuck it should move freely check it if its stuck soak it in carb cleaner you may need to take small needle nose pliers and grab it and give it a little twist to fee it be careful don't chew it up then soak it work it a few times.
Hope this helps

May 22, 2010 | 1993 Suzuki GS 500 E

2 Answers

Only stays cranked on full choke.


your carb. is gummed up. Get some carbeurator cleaner spray and spray it into the air intake as it is running until it clears up. if it wont clear up, you will have to have the carb rebuilt.

Sep 05, 2009 | Honda XR 250 R Motorcycles

1 Answer

Problem with the carb on 49cc mini bike


yes clean it with carb cleaner, take it off and take it all apart, every last piece and put it back together, it'll have trouble starting the first few pull but itll go

Jun 09, 2009 | Quad 47 cc / 49 cc Pocket Mini Bike...

Not finding what you are looking for?
New Ray Geico Honda CR250R Motorcycle Model Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top New Ray Toys Experts

Josh Van Nostrand

Level 2 Expert

62 Answers

Owen Barnes

Level 3 Expert

867 Answers

Bruce Burgess

Level 1 Expert

18 Answers

Are you a New Ray Toy Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...