Question about Hitachi UltraVision CineForm 55VG825 55" HDTV

1 Answer

Samsung HL -5656 fan light blinking BUT no other lights blinking

I have a Samsung DLP HL-t5656. The picture is out and when I try and turn it in the lamplight flashes 15-16 times then flickers and flashes another 11 times before going out entirely. I am sure I need a new bulb BUT the owners manual says all three lightsshould be flashing if anew bulb is needed. Ideas?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Hitachi Master
  • 737 Answers

Its probably not the lamp but I would try it first. Buy it from a place that will take it back as I suspect you have a bad power supply. http://support-us.samsung.com/cyber/popup/iframe/pop_troubleshooting_fr.jsp?

check this link against your symptoms and then check out Pureland Supply for a new lamp. Samsung DLP TV Lamp

Posted on Jan 10, 2018

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: 50vs 810 50in lcd rear projection

I have had this problem 3 times, and always is a bad signal assy.

Posted on Dec 24, 2007

  • 1 Answer

SOURCE: Hitachi model # 50V720

I have the same model and had the same problem after replacing the lamp. Turns out if the cover plate is not put back on properly, tv will not power on and lamp ligth comes on. To solve the problem all I had to do is tighten the cover plate screw. Hope this helps.

Posted on Jan 09, 2008

  • 1 Answer

SOURCE: Lights flashing and no piture or sound

I had the same problem a little over a year ago. It was the lamp. It needed to be replaced. I hope you have the extended warranty.

Posted on Jan 18, 2008

  • 3 Answers

SOURCE: tv screen stays black with the blue light and two red lights blinking

My tv had similar problems, except, the screen went black and there was a ticking sound coming from it. I took it to a tv repair man and what it needed was a "high voltage transformer." After that I had no other problems.

Posted on Jun 05, 2008

  • 927 Answers

SOURCE: Power button Flashes

Good Day, you all;

The front panel light on Hitachi TV does not really tell you much. To see what the TV is doing or better said NOT doing is remove back from the set.

If you are not a technical type person, it would be better to consult an authorized service center, but if you are perform this; 1. Remove back
2. Observe led and notice which once light, there are as many as 9 LED's.

Now that will tell you what area of the TV's circuits are to be concerned about.

Let me know, Good Luck, big IRISH.

Posted on Aug 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Samsung HL-P5067W/HL DLP tv. When I turn it on cold the lamp light blinks on and off. The fan makes a high pitch sound a relay clicks the TV goes back to standby and the lamp light starts blinking...


This sounds like a lazy lamp--that is getting hard to start. Try a new lamp first. If you are inclined to do so--get a bard bulb and install in the old lamp housing and save some money. Get a real PHILLIPS bulb--it will last a while--compared to cheap generics that are good for maybe 6 months !!

Feb 18, 2014 | Samsung HLP5067W Television

1 Answer

Samsung DLP turns on and off - cycle repeats


make sure put the lamp door back before trying to turn it on because they have switches on them that allow the tv to turn on. If that is ok you probably have a bad ballast.
Call a local tv repair shop to further diagnose the problem.

Dec 10, 2009 | Samsung DLP HL-P5663W 56" TV

1 Answer

I own a Samsung HL-R5067W 50'' DLP. Set is about 3 years old. Recently I heard a loud pop while viewing, picture distorted, but never went blank. I turned set off. When turned on again a loud whining noise...


Check your color wheel. There is a DIY guide for replacing the color wheel. Mine did the same thing yours is and my color wheel was all busted up. Unfortunately after replacing the color wheel my set continues to do the same thing, but this could mean I need to replace the ballast as well.

Sep 20, 2009 | Samsung DLP HL-P5663W 56" TV

1 Answer

SAMSUNG DLP HL-S5086W


check the horizontal transistor if, good.re solder your tv.

Sep 28, 2008 | Samsung DLP HL-P5663W 56" TV

1 Answer

STANDBY LIGHT TURN ON


when turning on the set will go three startup cycles about 2-3 min. then all three leds will blink/ possible causes /lamp/ballast/dmd board check or purchase the dmd board last (costs) also listen for arcing from the ballest at startup and fan noise if you can and color wheel noise also.if you hear the ballast arcing and trying to fire the lamp look at the lamp.

Jun 15, 2008 | Samsung DLP HL-P5663W 56" TV

4 Answers

Issues with replacing Ballast


I have some proble dlp tv I put new lamp;put the problem didnt whant away

May 05, 2008 | Samsung DLP HL-P4663W 46" Rear Projection...

Not finding what you are looking for?
Hitachi UltraVision CineForm 55VG825 55" HDTV Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hitachi Televison & Video Experts

Jaime Hernandez

Level 3 Expert

2337 Answers

The Knight
The Knight

Level 3 Expert

76099 Answers

Steve Allison
Steve Allison

Level 3 Expert

5569 Answers

Are you a Hitachi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...