An expert who has achieved level 2 by getting 100 points
An expert who has answered 20 questions.
An expert that has over 10 points.
An expert whose answer got voted for 2 times.
Re: Long beep and a blue screen, blank screen no menus
Operator panel display Service tip: The printer has detected a problem with the system card, the operator panel assembly cable (part of the top cover access assembly), or the operator panel assembly if POST does not complete. The printer emits 5 beeps, and sticks in a continuous pattern until the printer is turned off. Check for ground between JOPP1 pin 4 and ground. If correct, replace the operator panel assembly. Go to “Operator panel assembly removal” on page 4-22. If incorrect, check the operator panel assembly cable. If the cable is damaged, replace the top cover access assembly. Go to “Top access cover assembly removal” on page 4-23. If the cable is okay, replace the system card.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If display is blank you likely have a bad display or some other problem that will require replacements parts. Keep in mind that on Lexmarks the control panels are keyed to the formatter so you cannot just get a used panel from another printer, you must purchase a new one.
Error 83 indicates a problem referring to the transferbelt. Order a replacement transfer belt. When print quality is reduced, installthe new transfer belt using the instruction sheet that comes with the replacementtransfer belt.
For further assistance, please contact LexmarkTechnical Support.
Remove the supplies and clean the yellow printhead. For instructions on how to clean the printheads, click on this link: http://bit.ly/bCoz92. Just follow the instructions. If that doesn't help, might need replacement. If issue remains after printhead has been cleaned and the supply has been replaced, I suggest you contact Lexmark Technical Support for further assistance. Thanks.
Replacing the fuser
When 80 Fuser life warning appears on the operator panel, replace the fuser soon. Make sure one is on order. See
Ordering a fuser for more information.
When 80 Replace Fuser appears on the operator panel, replace the fuser immediately.
Operator panel display blank, five beeps, and LED off Service tip: The printer has detected a problem with the system card, the operator panel assembly cable (part of the top cover access assembly), or the operator panel assembly if POST does not complete. The printer emits five beeps, and sticks in a continuous pattern until the printer is turned off. Is this what you are getting?