Lost the remote & Sanyo Vizon is stuck on a "D" screen

hi

are you changing channels on the remote or on the tv?

take the batteries out of the remote and try and change the channels on the tv. if you can change channels fine on the tv then the remote buttons are stuck. usually in the battery area on the remote is a small screw take that screw out and disassemble your remote and use a q tip and rubbing alcohol to clean out your remote

tried with unplugging and re plugging the tv doesn't work?. if not, tried to push any button like the channel up/down button and tv/video button at the front panel.

On your cable remote, press the TV button to return your set to display cable channels.

The menu button is on your remote control, it is located at the bottom of the input button

ok maybe this will help.
make sure the video and audio are in the right place... setup:
  O OOX yellow OOX white OOX red OOO OOO
then turn device on (dvd/vcr) and on the remote press input button at the very top. this would set your device to video one screen, and you can watch whatever it is that you hooked up.
for cable or antenna hook that up then press reset button on remote ( bottom right hand side)

Press the DISPLAY button at its remote control once to vanish it.
If you wish to get some details; visit the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/

sanyo ds35590 no remote, tried universial remote still cannot select menu on uvm. What remote do I need? Or can I get into the menu without remote. I am trying to watch a dvd.

Yippie, I figured out a solution that worked!!! I have a univeral remote from comcast, on that remote near the bottom left is a small button that says (input) tv/vcr, press that one time and whala!! the tv video screen was gone, I had to manually change the channel from the tv channel button on the unit. once I changed the channel to 3, my universal remote worked... the button is the second one from the bottom left... I was on hold with sanyo for a long time and just kept trying on my own, so good luck!!!!

njdb,
Look on the remote for keys that are labled tv/vcr or source or input... In fact, if you go to the front of the unit - that's a Sanyo right - find the grouping of buttons that change the channel, volume etc.. There should be a button marked source or input there.. Press it as many times as it takes to get back to the input source your cable is on...
If you have any problems let me know...
Bill

Universal Remote should do it.