Question about Lionel Century Club 671 S2 Turbine Steam Locomotive

Open Question

How do i fix a lionel 671 turbine running slow then fast

Posted by Anonymous on


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 2047 Answers

SOURCE: on a lionel 2020 0r

The brush holders in the lionel 2020 steam turbine engine get hot after running for a couple of minute because they are a bit stiff. Some oil in between the holders and the brushes would enable it move smoother and ensure they dont get hot anymore.
Do be careful not to put too much oil in them and toy lubrication oil is recommended.
Hope this solution has been helpful?

Posted on Sep 24, 2010


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

The value of a train set 1953 Locomotive 1130

A Lionel 1130 is a "Scout" type locomotive....they are not particularly valuable even to collectors. They were a part of the low end starter sets Lionel made. Now if you had a similar vintage 736 Berkshire or a 681 or 682 Turbine they are worth considerably more.

Aug 10, 2016 | Crafts & Hobbies

1 Answer


if by real you ,mean a steam engine , as on real modern trains they don't stand ,they sit and they arnt in the back either , anyways on Baldwin 700's (from memory?) there was two low posts with large round knobs on top near operators cabin , these were Hip posts for coal stoker to lean on to support themselves as engine moved along but still allowed them to use there arms to stoke coal freely

Dec 03, 2015 | Lionel Century Club 671 S2 Turbine Steam...

1 Answer

The Lionel lines train is going too slow and it

time to clean & lube your train & track.
here's a couple link's that should help :
Maintaining Your Lionel Trains

Cleaning Track

Nov 11, 2014 | Crafts & Hobbies

1 Answer

My 1 ton onida ac is not giving cooling any more, the capacitor, gas pressure are ok, then too, but their is no relay in it, how is it, what's can be the problem, please suggest what to do,

ok number 1 most of ac units have its relay in the electronic board in the evaporative unit other have a contactor in the outer or condenser unit 2 if the capacitor and the pressure are good that means that the compressor is working, make sure the evaporator turbine is turning fast enouhg and is not build up in dirt if the turbine is running slow this makes the pressure go hi and trips the compressor relay or just wont blow air enouhg for you to feel it

May 28, 2014 | Heating & Cooling

1 Answer

My new lionel train slows down on far side of the track

There is bad contact in the track connections. You can sand the track connection sites. Another method is to run another power wire to the other end of the track where the train slows down. Even better is 3 or 4 evenly spaced power wires from the transformer to the track.

Jan 26, 2011 | Lionel New Haven Freight Train Set

1 Answer

I have Lionel 682 s2 turbine. Front axle and both front wheels are stripped. Wheels spin on axle. Need (2) 682-11 front wheels with boss. Need swaged front axle 681-18. Need (2) 681-23 center wheels. Need...

Your best bet is to take your locomotive to a Lionel Service Center. All these parts and diagrams are available but some special tools are required.

Oct 25, 2010 | Toys

1 Answer

Hoover sttem cleaner

The brushes spin by virtue of an air driven turbine. This turbine uses a little of the motor suction to turn a large fan which turns the brushes. If you look behind the clear glass window on the front right hand side of the machine, you will see a screen which acts as a filter to keep debris out of the turbine. If this screen becomes clogged, it will affect the flow of air to the turbine and the brushes will slow down or stop all togeather.
Also, if the lid of the recovery tank is not on correctly, the suction will be compromised and the brushes will not turn and the machine will not pick up water off the carpet.

Feb 04, 2008 | Hoover V1 SteamVac SpinScrub Vacuum

Not finding what you are looking for?
Lionel Century Club 671 S2 Turbine Steam Locomotive Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lionel Crafts & Hobbies Experts

Jeff Hogancamp
Jeff Hogancamp

Level 2 Expert

287 Answers

J.D. Browning
J.D. Browning

Level 3 Expert

2760 Answers

ray gallant

Level 3 Expert

46416 Answers

Are you a Lionel Craft and Hobby Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides