Sync more than 1 controller to dewy's adventure

Hello. you must first check that the batteries are good. then, check if your wii is working properly. if both don't help then you must get a wii or guitar!

If you hold the SYNC button in the SD Card Slot on the Wii console for too long (10 seconds or longer), all the remotes synced to your Wii will be erased and then you have to sync them and the Balance Board again.

Visit support.nintendo.com

Or call 1-800-255-3700 for assistance on your Wii

I had this problem and it was down to be, me plugging the motion plus into the wrong controller.
I have one control with intergrated motion plus and the other uses a plug on motion plus. I accidently plugged the plug on one into the already intergrated control leaving the one control with nothing. Hence that control could not be recognised.
Hope this helps

I had this problem and it was down to be, me plugging the motion plus into the wrong controller.
I have one control with intergrated motion plus and the other uses a plug on motion plus. I accidently plugged the plug on one into the already intergrated control leaving the one control with nothing. Hence that control could not be recognised.
Hope this helps

You probably need to sync the controller to the system. I am not sure if it works the same as the remote, but if you have the instruction booklet, it should tell you how to sync the controller.
Usually, there should be a sync button on the controller. Press it, and then press the sync button behind the sd compartment on the console.

Are both controllers synced? If not you will have to push a very small button underneath the controller in to sync it to the system. Good luck!

check the batteries on all the remotes. and try again. if the batteries are dead it will no sync.

This game is fun for the whole family. Amazon had the best price over the x-mas holiday ($21.00) so I could not miss it. There are issues with synchronization, which does NOT always happen during powering on, even after freshly installed batteries. I found these instructions and I think they are worth sharing:
Note: get a helping hand .. :) one for pressing the buttons on the controller and one for the game console.
1. Turn the game console off and on again and press the A button on the controller. If this does not re-establish the sync (and in my case it did not) then:
2. Press and HOLD BOTH the B button and the MENU button (on the bottom part marked "menu/off") on the controller. While pressing these PRESS the sync button on the game controller (white next to the big red power on/off).
Wait several seconds for the controller to attempt to sync with the game console. Once the game and controller have synced, the red LED light on the controller should be blinking slower.
And whoila! this did it for me.

start the guitar hero game as you normally would. then take the remote that you are going to put into the first guitar and press the "home" button", this should bring up a screen that will allow you to connect another remote in the game, press the reconnect area and aim both remotes at the sensor and press the 1 and 2 button at the same time, exit this screen and then got multiplayer section of the game and you should be set. my 10 year old neighbor had to show me this. good luck..

Try re-syncing the second (non-working) controller to the console. To do this turn both the controller and the 360 on, then find the little sync button on the 360 controller and hold it down until the lights flash in a clockwise circle. Now find the sync button on the 360 console and hold it down until the lights on the console spin in a clockwise fashion. Wait a couple seconds until the two sync up and then voila, you're good to go!

Here's pics of what the sync buttons look like: