Take apart ps30 fellowes shreddeder no screws

6th screw hidden under tiny round sticker

power supply are Fellowes Class 2 model (A57-013-15Z01)120 vac 60hz 39w 15vdc- 1.4 amp
The above is the specs for what you want. You can buy any generic or brand of power supply as long as your specs are the same and, of course, the ends (plugs) are the same as what you need. The very large on line store has many options

Take out the paper bin. Look for and remove any screws holding the top part of the shredder to the base. Take the top off, turn it upside-down and you might be able to remove the jam. To take the top apart, remove all of the screws that are under or near the edge. Look out, it gets very messy when you take it apart!
Fellowes sells replacement gears for some of their shredders.

once you take it apart it voids all warrants if you have any.
if you do not have any warrant parts than that the only way you are going to fix the issue.
here is what some one gave me some tips on disassembly of equipment. draw a picture of the device, mark the area of screw layouts, after separating the 2 parts draw diagram of each part, make foot notes on what you did, screw locations, parts removed, parts cleaned, PUT EVERYTHING IN A LINE IN THE ORDER OF REMOVAL PARTS, than work backwards and put everything back the way you took it apart, you should not have any extra parts and it should work fine. than if it every happens again you have your notes and information on hand to help you. you could try this site.

www.ask.com/
www.manualonline.com/
/mfg.name/make/model#/


www.mfg.name.wow/manuals/service/
www.manuals.wow.com/make/model#/service/repair/

www.disassembly.wow.com/mfg.name/make/model/instructions/

Your Fellowes p600c-2 shredderappears to have the same problem I had, it would run in reverse but would not shred new paper. I removed the 6 screws that are visible on the top assembly, but could not get the top assembly to come apart. There is a seventh screw hidden under one of the adhesive labels. I removed that screw and was able to disassemble the shredder. The plastic trigger mechanism that starts the shredder when paper is put in was stuck. I freed the trigger mechanism and reassembled the shredder. Now it works fine.

There is a screw hidden under one of the stick on labels. Remove that and the top comes just fine. I got it torn apart, completely cleaned of debris but the rollers still don't turn. I noticed an electrical arc when the switch is pressed so the unit is toast.

Never mind providing help, I fixed it myself. There is a seventh screw hidden under one of the adhesive labels. I removed that screw and was able to disassemble the shredder. The plastic trigger mechanism that starts the shredder when paper is put in was stuck. I freed the trigger mechanism and reassembled the shredder. Now it works fine.

Underneath one of the stickers in the center of the bottom is a screw

took schreder apart: The plastic driven gear it striped is that gear serviced

There are usually one or two hidden screws under the stickers.